Contestable Safety Precautions WARNING: DANGEROUS VOLTAGE INSIDE WARNING: TC PREVENT FIRE OR SHOCK HAZARD, BO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. *The POWER button does not completely shut off mains power from the unit, but switches operating current on and off, #The raking plate and the safely caution are on the rear of the unit. Introduction Congratulations on purchasing your new COR (Video Cassette Recorder). iris one of the most sophisticated yet simple-to-use home video recorders you can buy.
Front Panel 1 Cassette Compartment ‘Where the video cassette is inserted. 2 Wireless Remote Sensor Receives the: signal from the (wireless) remote control. 3 Button Press to rewind tapes. Also, during playback, press this ‘bitten for reverse visual search, 4 PLAY Bunion + Press to play back a tape. * Press to release the Slow or Search mode and rectum to playback. § FF {Fast Bunion Press to move the gate forward rapidly. Also, during playback, press this button for rapid forward visual search.
Description of C Is (cont'd] Rear Panel Remote Control Transmitter neg WEES Dee E 2234 % 220 2% 21 AC (Alternating Current) Power Cord Connect to a household outlet. 22 AUDIO IN(put) Jacks For audio input connection from the output jack of 2 potable video camera, another VCR, or another audit source, 23 AUDIO OUT(put) Jacks For connection to the audio input connector ona TV, another VCR, or an audio tape recorder. 24 VIDEO QUT(puf) Jack For video output connection another VCR.
PHILIPS 10 SLOW Bunion Press during SP or SLP playback to view a slow-motion picture. 11 STOP Button Press to stop the tape. 12 PAUSE/STILL Button + Press acne to temporarily stop the tape during recording (Pause), « Press once to freeze the tape picture during playback (Stilt). + Press again when you want to resume normal playback or recording. 13 VCR Channel) UP/DOWN Bunions Cross scan up or down through the VCR's channels. Release at desired channel.
Before Using Your VCR 1 ad The Batteries as Follows: 1 Remove the Battery Compartment | 2 Install two batteries as indicated 3 Replace the lid 1id from the bottom of the remote inside the Battery Compartment. control. &, Bottom of N Remote Control Battery Replacement Caution « Do not mix old and new batteries. (Also never mix alkaline batteries with manganese batteries.) This remote control and batteries are supplied accessories. Please check fo make sure they are included.
Hook Up Your VCR 7 1 VCR to TV Connection Step 1: Disconnect the Antenna or Cable from Your TV. Back of TV {example only) e, indoor Antenna Cable Step 2 Connect Your Antenna or Cable to Your VCR. ANT.IN Back of VCR {In from Antenna) S~ Step 3: Connect Your VCR to Your TV. ‘Both ends of the black RF cable are the Antenna or Cable same. Plug either end into the VCR, Now, Jug the other end into the TV, AC Power God ok of VCR B ANT. IN ™v Outta TV b @ Use the supplied conversion plug it necessary.
2 R Set the CH3/CH4 switch on the back of the VCR to channel operate the VCR with your TV, sel your TV to the same charmer. For example, if your switch is set to channel 3 ‘ (CH, turn your TV 10 channel 3. To avoid local interference, the CHANCY switch position you A choose should correspond to the Local TV channel that is not Outlet nosed or least used. £ both are used, select the channel that gives you the best pleasure when playing a tape.
Set the Clock 9 o set your VCR 1o the present day and dime, follow steps 1 —4 below. Once set, your VCR (Video Cassette Recorded} will maintain the time in its internal clock, and will make timer recording possible. dressmaker .. ) » your VCR and TV are connected and turned the VCR indicator says “VCR".
play a Tape To play a tape, follow steps 1 — 4 below. Make sure the batteries are Loaded in the remote control and the connections on pages 7 and 8 have been completed before continuing 1o the steps below. Tum the TV on. Set the TV to the same canned as the switch on the back of the VCR {CH3/CH4). PLAY Listerine] Button b Insert cassette* + The VCR Power will come on. (~STOP Bunion Start Playback Press the PLAY button, « The YCR mode is automatically set. “VCR” indicator will light.
‘o record on & cassette tape, follow steps 1 —7 below, Read all the instructions before starting. You mast use your remote control. v Power ON: Select channel 3rd. VCR Indicator VCR STOP Elocution Cassette RECTOR CHANNEL Tape Button UP/DOWN Buttons -, YCR i Channelize) UP/DOWN STOP Buttons Button NUMBER. Buttons Tape SPEED Bunion Remote Control Make sure the steps in “Hook Up Your VCR on pages 73 have been completed. i “Turn the TV on.
Record One Channel/See Another o record one channel while viewing another, follow steps 1 -4 below, Please read all the instructions. You ‘must use your remote control. Start a Recording 1 Start 8 recording as described on page 1L ANTENNA Set the VCR/TV Button Press the VCR/TV button 1o select the TV mode. The VER indicator disappears. {or CABLE) INPUT SELECT.
VCR Set Up Button Pressed Time Speed Counter Memory VCR Status Display nonessential TOED LUSHNESS Repeat Playback Selection HECTOR P SO PICTURE G OFF FORECLOSURE (oM PUNISHMENT Picture Control 0SD Main Menu Screen Press the MENU button on the remote to display the main menu screen. Then press the NUMBER button on the remote control} for the desired feature displayed on the menu. When you select 2 feature, tam to the section in this manual and read the accompanying instructions.
One Touch Recording (OTR) P70 set the VCR (Video Cassette Recorder) to automatically shut off after recording is completed, follow steps 1-3 Below, OTR lets you quickly specify how long you want recording to continue. You don’t have lo program the timer with this faction. You must use your remote control, + the steps in “Hook Up Your VCR” arc done, channels are programmed into the VCR’s memory, and the TV and VCR are both muted on, » the clock is set to the correct time.
Timer Recording 15 record while you's away, follow steps 1-12 below, For each program you set, the VCR will turn itself on, do the recording, and tum off automatically. You can store up to eight programs. Instructions for each step appear on the TV screen after you begin, You must use your remote control. Make sure « the steps in “Hook Up Your VCR™ have been » the clock is set to the correct time.
.Ti First, press two NUMBER buttons for the hour. Brushoff o Next, press two NUMBER buttons for the TIMEOUT R mint. Now, press NUMBER button “1” for AM or | (oo “2” for PM. JOENOPUGHIEIWS For example, for 9:30 PM, press NUMBER buttons First, press two NUMBER buttons for the hour. weirdie, 1 Next, press two NUMBER bunions for the o BP0 minute, For example, for I0:00 PM, press | conglomeration e Select the Recording Speed Press the 1 or 2 button to those SP (Standard i Play) or SLP (Super Long Play).
Special Playback Features 17 Is your VCR (Video Cassette Re carder) connected 1o your TV (see “Hank Up Your VCR*)? Are you familiar with tape playback (see “Play a Tape™)? I so, you ate ready o enjoy the special playback features described on [his page, These features work best in the SP (Standard Play) or SLP (Super Long Play) mode, You must use your remote control, To Rapidly Locate a Particular Segment First, press the PLAY button, Next, press the or FF (Fast button.
Special Playback Features (cont'd) Auto Operation Functions Auto Playback ‘When & tape is inserted, the power comes on, 1f the record tab* is removed, playback begins. 1 Auto Rewind ‘When & tape reaches iis end during playback, fast forward, or manual record, the VCR rewinds the tape and goes into Sta mode. Memory Rewind Power Off When the POWER button is pressed during rewind, the VCR. will g | BOWER turn off after rewind is complete.
Dubbing from any VHS recorder (or camcorder) to another is simple, Just use the connections and steps below. The example below vises two VCR Like this one. Other VCR may operate differently. Insert a per-recarded tape. VCR 1 is the VCR (Video Cassette CONNECTIONS 1 Recorder) that will play your tape. If the record tab Is missing (page 6), playback pianists. In that case, press the stop button, Source Insert a blank tape in the editing VCR. The VCR will tum on Camcorder | Player automatically.
Tape Counter Control f you always rewind your tapes fully and reset the tape counter, then you'll be able to use a list of program locations as an index. You must use your emote control, Select the Tape Counter Display “To select the tape counter display, press the STATUS button. The tape counter display appears on the TV screen, a8 Reset the Tape Counter “To reset the tape counter, press the CLEAR button. You can reset the coaster o zero at whatever point on the tape you choose.
. Postcode Setting 21 Your remote control may be able to operate the basic factions of your television. In addition to PHILIPS televisions, other manufacturer’s televisions Hated below can also be controlled by smelting the remote control to the corresponding. TV code, Initially, the code number is set to 01, Try Your Remote Control Point this remote control at your demote controllable TV and try the TV DOWER button. I it turns your TV on and off, try the other buttons. .
place receivable channels in your VCR (Video Cassette Recorder), folio steps 1w 4 below. This faction Tet you reprogram your VCR’s tuner at any time. With the Add/Delete feature you can add or delete any channel. You must use your remote control, Make sure « the steps on pages 7-$ have been completed, and your TV and VCR are on. « o make each entry within 60 seconds, otherwise the VCR will exit the Tuner Set Up mode and you will have to start over.
Notes on Operations 23 Hook Up Your VCR « If the reception on all channels is unsatisfactory, you may need 1o re-tune your TV set. Clock Adjustment « In the Clock Adjustment mode, be sure to enter the fists digit and all subsequent entries within 10 seconds of one another, Otherwise, the VCR will automatically leave this mode and the program you were watching will rectum to the serene. If this happens, press the MENU button and. start again, Be sure 1o enter “0” before single-digit numbers.
Before Requesting Service IMPORTANT NOTE: Periodic maintenance is requited in order to maintain the unit’s continued excellent performance. Afters period of dime the Video heads will require replacement. If cleaning or replacement of the Video fiends is required, this service should be performed by an authorized Video System Service Center. Check the following points once again if you ase having some difficulty with your VCR (Video Cassette Recorder). —Powerlessness. Power Failure...
~Remote Control ) 25 Correction VCR can't be remote controlled... + Aim the Remote Control directly at the remote sensor on. the VCR. + Avoid all obstacles which may interfere with the signal path, » Inspect or replace the batteries (B6). « Make sure batteries are inserted correctly (PS). I Miscellaneous You can't view programs normally on the TV.. Video cassette can't be inserted. Video cassette can’t be removed..
THE BEST CHOICE FOR YOUR VIDEO CASSETTE RECORDER Philips offers a full range of High Grade & Extra High Grade Video Cassettes.
