User Guide
— 5 —
17 Number buttons
(0, 1, 2, 3, 4, 5, 6, 7, 8
and 9)
Before using these buttons, press VCR,
TV or SAT to select yout target
component.
• Press to select a channel on the VCR
satellite tuner or TV.
To select channels 1 to 9, press 0
then the channel you want. For
example, for channel 4, press 0 then
4.
• Also used to programme the Timer
Recordings. (✈P.29, P30)
18 CLEAR button
• Erases unwanted timer programmes.
(✈P.31)
• Resets counter to 0:00:00.
19 STILL/SLOW button
• Stops the tape during recording
(pause) or playback (still picture)
temporarily. (✈P.22, P.23)
Press again to resume normal
recording.
Press PLAY 3 to resume normal
playback.
• Activates slow motion picture when
pressed for more than 2 seconds
during playback. (✈P.23)
20 STILL/SLOW / £ button
• During a slow motion picture, adjusts
the playback speed in the forward
direction (✈P.13)
Press PLAY 3 to resume normal
playback.
• Locates an index marked at the
beginning of every recording.
(✈P.23)
21 PLAY 3 / 5 button
Before using this button, press VCR or
TV to select your target component.
• After pressing VCR:
– Starts normal playback. (✈P.22)
– Moves up the cursor when using
the menus. (✈P.16)
• For some PHILIPS TV only:
After pressing TV, operates the TV’s
menus.
22 ¡ (Fast forward) /
3 button
Before using this button, press VCR or
TV to select your target component.
• After pressing VCR:
– Fast forwards the tape. Also during
playback, starts rapid forward
visual search. (✈P.21)
– Changes the setting of a menu
item. (✈P.16)
• For some PHILIPS TVs only:
After pressing TV, operates the TV’s
menus.
23 STOP 7 /
∞∞
∞∞
∞ button
• After pressing VCR:
– Stops the tape. (✈P.21)
– Moves down the cursor when
using the menus. (✈P.16)
• For some PHILIPS TVs only:
After pressing TV, operates the TV’s
menus.
24 CH (channel) 5 / ∞ button
Before using this button, press VCR,TV
or SAT.
• After pressing VCR, changes the
channels on the VCR. Release at a
desired channel.
• After pressing TV, changes the
channels on the TV. Release at a
desired channel.
• After pressing SAT, changes the
channels on the satellite tuner.
Release at a desired channel.
25 TIMER button
Displays the Timer Recording menu.
26 REC (ord) END SEARCH
button
Press prior to recording a programme to
find the end of previously recorded
program and the unrecorded portion of
a tape. (✈P.26)
To insert the batteries:
1 Remove the battery compartment lid
from the bottom of the remote
control.
2 Install two AA batteries —
R6(SUM-3)/AA — matching
polarity indicated inside the battery
compartment.
CAUTION
On Battery Replacement
Do not mix old and new batteries.
(Also never mix alkaline batteries
with manganese batteries.)
Note:
This remote control and batteries are
supplied accessories.
Check to make sure they are included.
Also, check “Specifications” to see what
other accessories are included.
3 Replace the lid.
27 SKIP SEARCH button
Press during tape playback to fast
forward 30 seconds of a tape. (✈P.23)
28 REC (record)/OTR button
• Starts recording when pressed once.
(✈P.22)
• Starts a recording for 30 minutes to 6
hours long. When pressed more than
once, the shut-off time increases in
30-minute intervals. (✈P.26)
29 Jog dial
Advances or reverses the picture frame
by frame in the still picture mode.
(✈P.23)
Note:
The following buttons will glow when you
use or place the remote control in the dark
area.
• PLAY
3
• STOP
7
•
¡
(Fast forward)
•
1
(Rewind)
• VOL (ume) 5/
∞
• CH (annel) 5/
∞
Untitled-2 16/08/2000, 15:345