User Guide

— 7 —
To insert the batteries:
1 Remove the battery compartment lid
from the bottom of the remote
control.
2 Install two AA batteries —
R6(SUM-3)/AA — matching
polarity indicated inside the battery
compartment.
23 STOP button
Stops the tape.
24 TV CH +/– button
Changes the TV channels. Release at a
desired channel.
25 DISPLAY button
Switches display between present time,
tape remaining time, time counter and
channel position. (✈P.22)
26 TIMER button
Displays the Timer Recording menu.
(✈P.29, P.30)
27 OK button
Changes the selection when using the
menus.
28 RECORD button
• Starts recording when pressed once.
(✈P.22)
• Starts a recording for 30 minutes to 6
hours long. When pressed more than
once, the shut-off time increases in
30-minute intervals. (✈P.26)
CAUTION
On Battery Replacement
Do not mix old and new batteries.
(Also never mix alkaline batteries
with manganese batteries.)
Note:
This remote control and batteries are
supplied accessories.
Check to make sure they are included.
Also, check “Specifications” to see what
other accessories are included.
Note:
The following buttons will light for 10
seconds when you press one of them.
• PROG. +/
• PROG. –/
• /
• /
• TV VOL (ume) +/–
• TV CH (annel) +/–
29 Jog dial
Advances or reverses the picture frame
by frame in the still picture mode.
(✈P.23)
R
VR1000/07-New 99.7.8, 3:28 PM7