Always there to help you Register your product and get support at www.philips.
Contents 1 Important 3 2 Your Alarm Clock 3 3 Get started 4 4 Set alarm timer 5 5 Other features 6 6 Product information 7 7 Troubleshooting 7 8 Notice 8 What's in the box Install battery Set clock Set alarm Activate/deactivate the alarm timer Snooze the alarm Turn the backlight on/off Attach the clip to your pillow Specifications 3 4 4 5 5 6 6 6 7 EN 2
1 Important • • • • • • • • • • • • • • • • 3 Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
3 Get started Always follow the instructions in this chapter in sequence. Set clock (Fig. ) c Install battery M O DE SE T Caution •• Risk of explosion! Keep batteries away from heat, MOD E SET sunshine or fire. Never discard batteries in fire. •• The batteries contain chemical substances, so they should be disposed of properly. Insert 3 AAA batteries with correct polarity (+/-) as illustrated. (Fig. ) b 2 sec SE T SE T 1 2 3 Tip •• When the low battery indicator the batteries.
4 Set alarm timer Alarm Indication Low-level vibration High-level vibration Buzzer Both Buzzer and vibration Set alarm Note 2 3 4 5 6 Press MODE to activate alarm setting mode. »» The current alarm time (if set) is displayed. Press and hold SET for 2 seconds. »» The hour digits blink. Press / to adjust the hour. Press SET to confirm. »» The minute digits blink. Repeat steps 3 to 4 to set the minute. Repeat steps 3 to 4 to set the alarm source. (Fig. ) f •• You cannot adjust volume manually.
5 Other features Snooze the alarm When alarm sounds, press SNOOZE. (Fig. ) g Turn the backlight on/off SNOOZE To turn the backlight on, press LIGHT. »» To save power, the backlight is turned off automatically after 5 seconds. Attach the clip to your pillow »» The alarm snoozes and repeats ringing nine minutes later. To prevent the alarm clock slipping off the bed, attach the supplied clip to your pillow case as illustrated. (Fig.
6 Product information Note •• Product information is subject to change without prior notice. Specifications Power supply (battery) 3 X 1.5 V AAA batteries Dimensions: -Main Unit (W x H x D) 82 x 82 x 19 mm Weight: -Main Unit 0.07 kg 7 Troubleshooting Warning •• Never remove the casing of this device. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this device, check the following points before requesting service.
Notice because correct disposal helps to prevent negative consequences for the environmental and human health. Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. Environmental information All unnecessary packaging has been omitted.
Specifications are subject to change without notice © 2013 Koninklijke Philips Electronics N.V. All rights reserved. TCJ330_12_UM_V1.
