Clock Radio 4000 Series R4406 User manual Register your product and get support at： www.philips.
Contents 1 Important Safety FCC information 2 Your clock radio Introduction What's in the box Overview of the clock radio 3 Get started Install batteries Connect power Set time 4 Listen to FM radio Tune to FM radio stations Store FM radio stations automatically Store FM radio stations manually Select a preset radio station Adjust volume 5 Other features Set alarm time Set sleep timer Adjust display brightness Charging device via USB port 2 2 2 3 3 3 3 4 4 4 4 5 5 5 5 5 5 6 6 6 6 6 6 Product informati
1 Important Safety FCC information • • • • NOTE: This equipment has been tested and • • • Read these instructions. Heed all warnings. Follow all instructions. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
2 Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/support. Overview of the clock radio 1 • Turn on or switch to standby. 2 Introduction With this clock radio, you can • listen to FM radio； • set two alarms to ring at different times； • charge your mobile devices. 3 HR / MIN / TUN • Set hour and minute. • Tune to FM radio stations. 4 SNOOZE / BRIGHTNESS • Snooze alarm.
3 Get started Always follow the instructions in this chapter in sequence. Install batteries Note • The type plate is located at the bottom of the clock radio. Connect the power adaptor to the wall outlet. The batteries can only back up clock and alarm settings. Caution • Risk of explosion! Keep the batteries away from heat, sunshine or fire. Never discard batteries in fire. • Batteries contain chemical substances, so they should be disposed of properly. • Do not mix battery types: e.g.
4 Listen to FM radio Note Note • • Keep the clock radio away from other electronic devices to avoid radio interference. For better reception, fully extend and adjust the position of the FM antenna. Tune to FM radio stations 1 Press to turn on the clock radio. 2 Press and hold TUN • Store FM radio stations manually 1 In FM tuner mode, tune to an FM radio station. 2 Press and hold PRESET for 2 seconds to activate programming mode. The preset number begins to blink. for 2 seconds.
5 Other features Set alarm time Set alarm Note • • You can only set the alarm in standby mode. Make sure that you have set the clock correctly. 1 In standby mode, press and hold AL1 or Set sleep timer This clock radio can switch to standby mode automatically after a preset period. • Press SLEEP repeatedly to select a period (in minutes). The clock radio switches to standby mode automatically after the preset period. To deactivate the sleep timer: • Press SLEEP repeatedly until [OFF] (off) appears.
6 7 Product information Note • Warning Product information is subject to change without prior notice. Amplifier Rated Output Power Troubleshooting 700mW RMS Tuner (FM) Tuning Range 87.5-108 MHz Tuning Grid 100 KHz Sensitivity - Mono, 26 dB S/N Ratio <22 dBf Total Harmonic Distortion <3% Signal to Noise Ratio >50 dBA • Never remove the casing of the product. To keep the warranty valid, never try to repair the device yourself.
2021 © MMD Hong Kong Holding Limited. All rights reserved. Specifications are subject to change without notice. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited or one of its affiliates, and MMD Hong Kong Holding Limited is the warrantor in relation to this product. TAR4406_37_UM_V1.
