Clock Radio 3000 Series R3205 User manual Register your product and get support at www.philips.
Contents 1 Important Safety 2 2 2 Your clock radio 3 3 3 3 3 Get started 4 4 4 4 4 Listen to FM radio 5 5 5 5 5 5 Other features 6 6 6 6 Product information 7 7 Troubleshooting 7 8 Notice 8 Introduction What's in the box Overview of the clock radio Install batteries Connect power Set time Tune to FM radio stations Store FM radio stations manually Select a preset radio station Adjust volume Set alarm time Set sleep timer EN 1
1 Important Safety Warning • Never remove the casing of this clock radio. • Never lubricate any part of this clock radio. • Never place this clock radio on other electrical equipment. • Keep this clock radio away from direct sunlight, naked flames or heat. • Make sure that you always have easy access to the power cord, plug or adaptor to disconnect the clock radio from the power. • • • • • • • • • • 2 Read these instructions. Heed all warnings. Follow all instructions.
2 Your clock radio Overview of the clock radio a. Congratulations on your purchase, and support that Philips offers, register your product at www.philips.com/support. Introduction With this clock radio, you can • listen to FM radio; • set two alarms to ring at different times. What's in the box Check and identify the contents of your package: • Main unit • AC power adaptor • Quick start guide • • Turn on or switch to standby. b. PRESET / SET TIME • Store radio stations in memory.
3 Get started Note • The type plate is located at the bottom of the clock radio. Always follow the instructions in this chapter in sequence. Install batteries The batteries can only back up clock and alarm settings. Caution • Risk of explosion! Keep the batteries away from heat, • Batteries contain chemical substances, so they should be disposed of properly. Set time Note • You can only set time in standby mode.
4 Listen to FM radio Note •• Keep the clock radio away from other electronic devices to avoid radio interference. •• For better reception, fully extend and adjust the Tip •• To remove a pre-stored station, store another station in its place. Select a preset radio station In FM tuner mode, press PRESET repeatedly to select a preset number. position of the FM antenna. Tune to FM radio stations 1 2 Press Adjust volume While listening, press VOL to adjust volume. to turn on the clock radio.
5 Other features »» The alarm repeats ringing for the next day. Set alarm time Snooze the alarm Set alarm Note •• You can only set the alarm in standby mode. •• Make sure that you have set the clock correctly. 1 In standby mode, press and hold AL1 or AL2 for 2 seconds to set alarm time. 2 Press HR to set hour and MIN to set minute, then press AL1 or AL2 to confirm. Tip •• The unit exits alarm setting mode when being idle for 10 seconds.
6 Product information 7 Troubleshooting Warning Note • Never remove the casing of the product • Product information is subject to change without prior notice. Rated Output Power 200mW RMS Tuner (FM) Tuning Range Tuning Grid Sensitivity - Mono, 26 dB S/N Ratio Total Harmonic Distortion Signal to Noise Ratio 87.
8 Notice Any changes or modifications made to this device that are not expressly approved by MMD Hong Kong Holding Limited may void the user’s authority to operate the product. Hereby, TP Vision Europe BV declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.You can find the Declaration of Conformity on www. philips.com/support. This product complies with the radio interference requirements of the European Community.
Specifications are subject to change without notice. 2020 © Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited or one of its affiliates, and MMD Hong Kong Holding Limited is the warrantor in relation to this product. TAR3205_12_UM_V1.
