User manual

6 EN
3 Get started
Charge the battery
 Before you use your headphones, place them
in the charging box and charge the battery for
two hours for optimum battery capacity and
lifetime.
 Use only the original USB charging cable to
avoid any damage.
 Finish your call before charging. Connecting
the headphones to charge will power them
o.
Connect the supplied Type C charging
cable to:
• Type C charging slot on the head-
phones and;
• The charger/USB port of a
computer.
 Normally, a full charge takes 2 hours.
Pair the headphones
with your mobile phone
Make sure that the headphones are
fully charged and turned o.
The headphones remain in
pairing mode for 5 minutes.
Before you use the headphones with
your mobile phone for the rst time,
pair it with a mobile phone. A successful
pairing establishes a unique encrypted
link between the headphones and
mobile phone. The headphones store
the last 4 devices in the memory. If you
try to pair more than 4 devices, the
earliest paired device is replaced by the
new one.
LED turns blue during charging and
turns o when the headphones is
fully charged.
Press and hold for 4 seconds
until the blue LED ashes quickly.
Make sure that the mobile phone is
turned on and its Bluetooth feature
is activated.
The following example shows you how
to pair the headphones with your
mobile phone.
Pair the headphones with the
mobile phone. For detailed infor-
mation, refer to the user manual of
your mobile phone.
Activate the Bluetooth feature of
your mobile phone, select
Philips TAA6606.
Philips TAA6606
Tip
Note
1
2
3
4
1
2
Enter the headphones' password
"0000" (four zeros) if prompted.
For those devices featuring Blue-
tooth 3.0 or higher, there is no need
to enter a password.