User manual

Problem Possible cause Solution
To clean the shaving heads
thoroughly, remove the
shaving heads from the
shaving head holder one
by one (see 'Replacement').
Then separate the cutter
from its guard and rinse
each matching set under
the tap. After rinsing, place
the cutter back into its
corresponding guard.
Finally, put the shaving
heads back into the
shaving head holder (see
'Replacement').
I replaced the
shaving heads,
but the
replacement
reminder is still
showing.
You have not reset
the replacement
reminder.
To reset the replacement
reminder, press and hold
the on/off button for
approx. 7 seconds.
Water is leaking
from the bottom
of the appliance.
During cleaning,
water may collect
between the inner
body and the outer
shell of the
appliance.
This is normal and not
dangerous because all
electronics are enclosed in
a sealed power unit inside
the appliance.
27
English