Operation Manual

B Let go of the ash button after each ash.
For the next ash, place the appliance on the area
right next to the previously ashed area. Make sure
the safety ring is fully pressed onto the skin.
This ‘Step & Flash mode’ guarantees a precise
treatment of e.g. the knees or ankles.
Note: After a few seconds, the appliance is ready to
ash again, so make sure that you move it to the next
area immediately after it has ashed.
Do not treat exactly the same area multiple times
during one session. This does not improve the
effectiveness of the treatment, but increases the
risk of skin reaction.
Note: The visible light produced by the appliance is the
reection of the ash on the skin and is harmless to your
eyes. It is not necessary to wear goggles during use.
8 To avoid untreated areas, always make
sure there is some overlap with the previously
treated area when you place the appliance on
the skin.The effective light only comes out of
the light exit window with integrated UV lter.
Make sure the ashes are produced close to
each other. Ask somebody else to help you
with the treatment if you want to treat your
back to ensure that the treated areas overlap.
9 Switch off the appliance after you have nished
the treatment.
10 Check the body attachment and light exit
window for hairs and dirt and clean the
appliance after use. See chapter ‘Cleaning and
maintenance’.
ENGLISH26