Replacement Remote SRP4030 TAPR802 Replacement Remote for LG® TVs Ersatzfernbedienung für LG® Fernseher Télécommande de remplacement pour téléviseurs LG® User manual Register your product and get support at www.philips.
Contents Insert batteries (not included) 2 Introduction 2 Manual set up by code selection 3 Auto IR code search 4 Code Learning 5 Disposal of your old product and battery 6 Frequently asked questions 7 Need help? 7 EN 1
Your replacement remote Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome Insert batteries (not included) Warning •• Check the battery polarity when inserting in the battery compartment. Incorrect polarity may damage the product. Caution •• Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire.
Manual set up by code selection List of IR code for LG and Philips TVs LG TV 00000 00001 00002 00003 00004 00005 00006 00007 00008 00009 00010 00011 00012 00013 The replacement remote RRC has preprogrammed the most updated IR code and is ready to use. If it does not work, you can manually select the code from our list that can fit your TV. Set up by code selection 1 Switch on your TV.
Auto IR code search 1 Turn off your TV with stand-by power 2 Press and hold 1 and 6 at the same time for 5 seconds until the red LED is on. 4 5 When the TV turn on (it might takes a few seconds for some TV to power on), you can try other keys (except PLAY and STOP) to see if the TV response. You can press STOP to confirm and exit the search. If most of the other keys does not work properly, turn off your TV and press PLAY again to try the next code.
Code Learning Note You must have an original remote for the Replacement Remote Control (RRC) to learn code from it. Learn commands 1 2 3 Press and hold 1 and 6 at the same time for 5 seconds until the red LED is on. Enter the learning code 9 9 9 0 0 . The red LED light will flash once and then remains on. Place the RRC and the original remote, head to head aiming at each other, o n a flat surface.
Disposal of your old product and battery Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. This symbol on a product means that the product is covered by European Directive 2012/19/EU. This symbol means that the product contains batteries covered by European Directive 2013/56/EU which cannot be disposed of with normal household waste.
Frequently asked questions My replacement remote does not work at all. • Check if you have correctly setup the device with the right code. Check if you have pressed the corresponding device key for your device. • Check if the batteries are inserted properly. If the battery level is low, replace the batteries. • Check if your device is powered on.
Specifications are subject to change without notice. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited or one of its affiliates, and MMD Hong Kong Holding Limited is the warrantor in relation to this product. SRP4030_10_UM_V1.0 P Vision Europe B.V.
