Always there to help you Register your product and get support at www.philips.
Contents 1 Your universal remote Introduction Overview of the universal remote Supported devices 2 Get started Insert batteries (not included) Set up the universal remote 2 2 2 3 4 4 4 3 Notice 7 Disposal of your old product and battery 7 4 Service and support Frequently asked questions Need help? 8 8 8 EN 1
1 Your universal remote Overview of the universal remote a Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome b c Introduction d With the universal remote, you can operate up to 8 different devices. e f g a INPUT: select available source inputs (antenna, cable, etc.). : LED indicator : power on or off. b Device selection buttons c GUIDE: displays the program guide.
CH+/-: go to the next/previous channel. : mute LAST: return to the previous tuned channel. : previous track : stop : next track : play : pause : rewind : record : fast forward e f / / / : teletext off/teletext mix/ teletext on/teletext hold g Digit buttons I/II: select the audio channel. -/--: select between one and two-figure channel numbers.
2 Get started Manual registration 1 Switch on your device. Insert batteries (not included) 2 Press and hold the device selection button (e.g. TV) for 5 seconds until the red LED is on. Warning •• Check the battery polarity when inserting in the battery compartment. Incorrect polarity may damage the product. Caution •• Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire.
5 6 If the light is off, a valid code is saved. Otherwise, the light will flash once, and then remains on for code re-entry. 2 Operate the device with the universal remote. If your device responds correctly, it means you have entered the right code. Otherwise, repeat from step 2, and enter the second code on the list. 3 Note Press and hold the device selection button (e.g. TV) for 5 seconds until the red LED is on. Point at your device with the universal remote.
4 When the device is off, immediately press and release OK to save the code. The red LED indicator will turn off. max. 20 minutes 5 Operate the device with the universal remote. If your device responds correctly, it means you have saved the right code. Note •• Auto registration can be reversed, by pressing and releasing once more during the auto registration process. This is helpful if you missed out the chance to press OK within 2 seconds. Make sure that the device is first powered on again.
3 Notice Disposal of your old product and battery Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.
4 Service and support Frequently asked questions My universal remote does not work at all. •• Check if you have correctly setup the device with the right code. •• Check if you have pressed the corresponding device key for your device. •• Check if the batteries are inserted properly. If the battery level is low, replace the batteries. •• Check if your device is powered on.
2016 © Gibson Innovations Limited. All rights reserved. This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V. UM_SRP2018_10_EN_V1.
