Register your product and get support at www.philips.
• • • This manual contains important information about the Philips power strips. Read it carefully before you start the installation and setup. Warning Increase the separation between equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. English 1 Important safety instructions Recycling •• Do not operate your power strip near the rain or wet areas.
2 Your power strip Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips. com/welcome. Overview a MIN • Set the minute. b PROG • Set the program. c MODE • Set a working mode. d Outlet e TIMERRESET • Erase the programs. f CLOCK • Set the time. g Display panel • Show current status. 4 EN h Circuit breaker • Switch the power strip on or off. i DAY • Set the day. j HOUR • Set the hour.
English 3 Get started Warning •• To avoid any potential hazard, use the power source supplied by your local authorities. 1 2 3 4 Plug the power strip into a properly grounded outlet. Plug the electric appliances into the power strip. Switch the circuit breaker to RESET ( ). Press TIMERRESET to erase the programs before the setup ( ). b a Tip •• You can use a tiny slim tool to press TIMERRESET.
4 Set the time 1 2 3 6 Press and hold CLOCK, then press DAY repeatedly to set the day. Press and hold CLOCK, then press HOUR repeatedly to set the hour. Press and hold CLOCK, then press MIN repeatedly to set the minute.
Press CLOCK to quit the program setting. »» The programs are saved. »» The current time is displayed. You can set programs to control the electric appliances with this power strip. 1 Press PROG, the following is displayed. AM PM ON RDM OFF AUTO 2 3 4 •• At most seven programs can be preset by all days of the weeks, any single day of the week weekdays only or weekends only. The saved programs take effect at the same time.
6 Select the mode Press MODE repeatedly to select a working mode of the power strip: • AUTO: the outlets are controlled by the saved programs automatically. • RDM: the outlets are controlled by the saved programs, randomly within 30 minutes before or after the programmed times. • ON: the outlets are always on. • OFF: the outlets are always off.
7 Limited warranty Philips, Inc. (“Philips”) provides one or both of the following warranties (Surge Protector Limited Warranty and Connected Equipment Limited Warranty) to the original consumer of surge protectors sold under the Philips brand names. These warranties apply only to natural purchasers of surge protectors for personal, family or household use, not to commercial, institutional or industrial purchasers. These warranties are valid only in US.
© 2012 Koninklijke Philips Electronics N.V. All rights reserved. SPS6060A_UM_17_V1.
