Register your product and get support at www.philips.
This manual contains important information about the Philips remote controlled outlets. Read it carefully before you start the installation and setup. Warning •• Do not operate your remote controlled outlets near water. •• Do not operate your remote controlled outlets if liquid of any kind is spilled onto or inside the unit. •• Do not disassemble or repair.
2 Your remote controlled outlets a Button A • Turn on/off the outlet of Receiver A. b Button B • Turn on/off the outlet of Receiver B. c Button C • Turn on/off the outlet of Receiver C. Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips. com/welcome. d Button ALL ON • Turn on all the outlets of all receivers. e Button ALL OFF • Turn off all the outlets of all receivers.
2 3 Insert one A23 battery with correct polarity (+/-) as indicated. Close the battery compartment. English 3 Get started Note •• To avoid any potential hazard, use the power source supplied by your local authorities. There are three receivers and one remote control. You can control up to three receivers with the remote control. 1 Plug the receivers into a properly grounded outlet. 2 Plug your devices into the AC outlet of receivers.
4 One Year Limited Warranty (USA only) Philips warrants that this product shall be free from defects in material, workmanship and assembly, under normal use, in accordance with the specifications and warnings, for a period of one year from the date of purchase. This warranty extends only to the original purchaser of the product, and are not transferable.
© 2012 Koninklijke Philips Electronics N.V. All rights reserved. SPS6010A_UM_17_V1.
