User Manual

Switching on the adaptation phase
At any time after the adaptation phase, you
can manually switch on the adaptation phase
again. Use the same 5-second long press as
described in ‘Switching off the adaptation
phase’.
The small dot on the display of the sensor
indicates that the adaptation phase is active
again during 7 sleep sessions. With this re-
activation of the adaptation phase, the data of
your last sleep session has been removed.
Vibration level
The sensor is smart and has a self-learning
algorithm. The sensor optimizes the vibration
level based on your reaction time (response
rate).
Vibration patterns
Every five days, the vibration pattern changes
to make sure that you do not get used to the
vibrations and that you will keep responding
to them.
Resetting the sensor
Reset the sensor if you want to remove your
data and reset the adaptation phase (e.g.
other user, a long period of disuse).
5
sec.
To reset the sensor, press and hold the
activation button for five seconds when the
sensor shows one of the data screens.
The sensor vibrates after two seconds, but
keep the button pressed until the sensor has
21