Register your product and get support at www.philips.
1 Important 4 4 4 4 4 5 5 2 Your SDV8622T/55 5 6 Safety For indoor use For outdoor use Notice for USA Notice for Canada Recycling What’s in your box English Contents 3 Get started 7 Installation 7 Connect to the TV 10 Set up a digital tuner with this antenna 10 4 Frequently asked questions 11 5 Warranty and service 11 6 Glossary 12 EN 3
1 Important Safety • Properly sealed against leaks at the installation site. • Do not install your antenna on a wet or windy day. • If the assembly starts to drop, get away from it immediately. Remember: the antenna, mast, cable, and metal guy wires are all excellent conductors of electrical current. Even the slightest touch of any of these parts to a power line can cause electrocution and death.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. All other devices shall bear the following statement in a conspicuous location on the device: This device complies with part 15 of the FCC Rules.
What’s in your box 2 1 1x 4 3 1x 5 1x 7 6 2x 9 10 2x 8 4x 12 11 1x 1x 1x 4x 13 4x 14 1x a SDV8622T/55 antenna h 25mm wood screws b Power supply 100-240V AC / 6V DC 500mA i 6m coax cable with connectors j Weather boot c Wall/Mast bracket k Power inserter d Nut l Plastic anchors e U-Bolts m Washer f Mast clamps n 40mm Hexagon screw g Nuts with lock washers 6 EN 1x
Installation Installation information This antenna uses a power inserter module to power the antenna amplifier. It is essential for proper operation of this antenna system that the power inserter be connected between the antenna and any devices such as splitters, matching transformers, networks, etc. Determine the signal strength Before Installation, determine the best location for optimum reception. It is important for the antenna to have an unobstructed path to the transmitter.
For outdoor mast mount installation Note •• Complete all assembly work on the ground. Raise the completed antenna after assembly. 1 3 Use the nut , washer , and hexagon screw to attach the antenna to the wall/mast bracket. Use the wood screws to fix the antenna to the wood wall firmly. 3 2mm (1/8”) 27±5mm 1 1”±0 2” 2 7 9mm (5/16”) 35±5mm 1 4”±0 2” 8 EN Insert U-bolts into the holes of the wall/mast bracket . Slide the mast clamps onto the U-bolts .
3 Attach the assembly to the mast firmly. Rotate 4 5 English You can make a 90 degree rotation to the antenna or the mounting post. Rotate the mast in its mount to adjust the direction. Attach the coaxial cable to the F connector on the underside of the unit. Position the weather boot over the connection.
Warning •• The power inserter and power supply are for indoor use only. Tip •• This antenna includes a 6m roll of 3C-2V coaxial cable. If this is not adequate for your needs, replace the cable with a RG-6 coaxial cable instead of adding an extension. Set up a digital tuner with this antenna Connect to the TV Note •• As previously noted, the amplifier (Power inserter + Power supply) must be placed inline between the antenna and any splitter or additional devices.
5 Warranty and service Can this antenna work with Analogue transmissions? Yes, this antenna can receive analogue television broadcasts in the UHF and VHF bandwidths. Warranty information can be found at: www. philips.com/welcome Will this antenna receive digital or work with high definition (HD) broadcasts? Yes, this antenna is designed to receive Digital and HDTV broadcasts in the UHF and VHF bandwidths.
6 Glossary A Amplifier A device, either a single stage or a large scale circuit with multiple stages for creating gain, i.e. it makes small signals larger. Antenna A device, such as a rod or wire, which picks up a received radio frequency signal or radiates a transmitted RF signal. C Coaxial A single copper conductor, surrounded with a layer of insulation, covered by a surrounding copper shield and finally, an insulating jacket. An unbalanced transmission line with constant impedance.
© 2012 Koninklijke Philips Electronics N.V. All rights reserved. DFU_SDV8622T_55_V1.
