operation manual

Before using the bottle
-
Inspect the bottle and feeding teat before each use and pull the feeding teat in all directions to
prevent a choking hazard. Throw away at the first signs of damage or weakness.
-
Clean and disinfect the bottle before first use and after every use.
Assembling the bottle
1. The teat is easier to
assemble if you wriggle
it upwards instead of
pulling it up in a straight
line.
2. Make sure you pull the
teat through until its
lower part is aligned with
the screw ring.
3. Make sure you place
the cap vertically onto
the bottle so that the
teat sits upright.
4. Screw the screw ring
with teat and cap on the
bottle.
5. To remove the cap,
place your hand over the
cap and your thumb in
the dimple of the cap.
Heating breast milk
If you use frozen breast milk, let it defrost completely before you heat it.
Note: If you need to feed your baby quickly, you can defrost the milk in a bowl of hot water.
Heat the bottle with defrosted or refrigerated breast milk in a bowl of hot water or in a bottle warmer.
Remove the screw ring and sealing disc from the bottle.
Always stir or shake heated breast milk to ensure even heat distribution and test the temperature
before serving.
Warning: It is not recommended to use a microwave to warm up breast milk.
Microwaves might alter the quality of breast milk and destroy some valuable nutrients
and may produce localized high temperatures. If you heat up breast milk in the
microwave, only place the container without screw ring, teat and cap in microwave.
Always stir heated breast milk to ensure even heat distribution and check the
temperature before serving.
18
English