operation manual

13
English
Note
•
You do not need to use all
stimulation/expression levels,
only use the levels that are
comfortable for you.
•
Place the pump motor on a
stable and at surface, or hang
up steadily with the included
sling, to avoid any accidental
drops when in use. If not, this
may pull the pump body o from
the breast and cause injury.
•
If you regularly express more
than 125ml per session on each
breast, you can use a 260ml/9
oz Philips Avent bottle to prevent
overlling and spillage.
•
If there is no operation on this
appliance (such as pause, change
stimulation level and expression
level) for 30 minutes (including
in pause), the appliance will shut
down automatically.
7 When you have nished
expressing, press the power
button ( ) to switch o the
breast pump and carefully
remove the pump body from
your breast.
Tip
•
After switching o the breast
pump, break the seal between
the breast and the pump funnel
with your nger, and then remove
the pump from your breast.
8 Disconnect the the power plug
to the power socket, and then
disconnect the power adapter
from the pump motor. (Fig. 18)
» The expression indicator lights
up instead of the stimulation
indicator.
Note
•
Do not worry if your milk does
not ow immediately. Relax and
continue pumping. The rst few
times you use the breast pump,
you may need to use a higher
expression mode to get your milk
owing.
•
Stimulation and expression
levels match to the number of
the owers lighting up. That is,
1 ower lighting up means level 1,
and 2 owers lighting up means
level 2.
•
When needed, you can also
use stimulation mode to do
expression.
6 During expression, you can
switch between the stimulation
mode and expression mode by
pressing the mode selection
button ( ) for better expression.
(Fig. 17)