User guide

Note: We strongly advise you to use Philips non-rechargeable batteries.

Only replace the adapter of the baby unit with an adapter of the original type.You can order a new
adapter from your dealer or a Philips service centre.
UK only: BD075040D
Other countries: VD075040D
Parent unit

Only replace the battery pack of the parent unit with a Li-ion 1000mAh battery pack.

Only replace the adapter of the parent unit charger with an adapter of the original type. You can
order a new adapter from your dealer or a Philips service centre.
UK only: SSA-5W-09 UK 075050F
Other countries: SSA-5S-09 EU 075050F

Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an ofcial collection point for recycling. By doing this, you help to preserve the
environment (Fig. 34).
Non-rechargeable batteries and battery packs contain substances that may pollute the
environment. Do not throw away non-rechargeable batteries and battery packs with the normal
household waste, but hand them in at an ofcial collection point. Always remove non-
rechargeable batteries and battery packs before you discard and hand in the appliance at an
ofcial collection point.

If you need service or information or if you have a problem, please visit the Philips AVENT website
at www.philips.com/AVENT or contact the Philips Consumer Care Centre in your country (you
nd its phone number in the worldwide guarantee leaet). If there is no Consumer Care Centre in
your country, go to your local Philips dealer.

This chapter lists the questions most frequently asked about the appliance. If you cannot nd the
answer to your question, contact the Customer Care Centre in your country.
Question Answer
Why don’t both the
power-on light of the
baby unit and the LINK
light of the parent unit
come on when I press
the on/off buttons of the
units?
Perhaps the rechargeable battery pack of the parent unit is empty and
the parent unit is not in the plugged-in charger. Insert the small
appliance plug into the charger, put the adapter of the charger in a
wall socket and place the parent unit in the charger. Then press the
on/off button to establish connection with the baby unit.
Perhaps the non-rechargeable batteries of the baby unit are empty
and the baby unit is not connected to the mains. Replace the non-
rechargeable batteries or connect the baby unit to the mains. Then
press the on/off button to establish connection with the parent unit.
-
-
-
-
-
-
ENGLISH 17