operation manual

2 Remove the tip from the appliance.
3 Clean the tip under the tap with hot water (max. 70°C) and some
washing-up liquid. If the exfoliation ring is dirty, let the tip soak in hot
water with washing-up liquid or in alcohol solution for 5-10 minutes. You
can use the brush to clean it. Make sure you clean the filter of the tip
upside down to rinse off any dirt left in the filter. Dry the tip with a lint-
free towel or leave it to air dry. Place it back onto the handle when it is
dry.
4 Clean the handle with a damp cloth.
5 Place the dry treatment tip back onto the appliance.
6 Wipe the charging stand with a damp cloth.
Danger: Keep the adapter and the charging stand dry. Never immerse
them in water or rinse them under the tap.
Clean the treatment tip after each use for hygienic reasons and to prevent
clogging of the filter. Only use washing up-liquid or an alcohol solution (max
70%) to clean the treatment tip.
Storage
Store the appliance with the tip attached in the charging stand or pouch.
Note: Do not store a wet treatment tip on the appliance or in the pouch.
Replacement
For optimal results, it is recommended to replace the tips every six months
(or earlier if the abrasive structure is deformed or damaged). Replacement
tips are available on our website. The tip can be identified by the product
code. You can find this code on the inside of the tip.
Ordering accessories
To buy accessories or spare parts, visit www.shop.philips.com/service or go
to your Philips dealer. You can also contact the Philips Consumer Care
Center in your country (see the international warranty leaflet for contact
details).
13
English