Register your product and get support at www.philips.
a b c d e f g
BEEP PHILIPS SBT30
1 Important Safety Important Safety Instructions • • • • • • • • • Heed all warnings. Follow all instructions. Do not use this apparatus near water. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other devices (including amplifiers) that produce heat. Only use attachments/accessories specified by the manufacturer. Refer all servicing to qualified service personnel.
Notice Any changes or modifications made to this device that are not expressly approved by WOOX Innovations may void the user’s authority to operate the equipment. Hereby, WOOX Innovations declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. You can find the Declaration of Conformity on www.philips.com/support.
Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.) Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.
Power supply The speaker can operate on built-in rechargeable battery. To recharge the built-in battery: Connect micro USB socket( ) with PC through supplied USB cable. »» The power indicator( ) turns on. • The power indicator turns off when it’s fully charged. The carabiner The carabiner( ) is used for easy carrying or hanging, not for climbing support or fall protection.
When there is an incoming call: • Press Bluetooth button( 2 ) to pick up the call. • Press Bluetooth button( 2 ) again to hang up the call. Tip •• You can speak to the MIC( ) to get the best speakerphone performance. Play from an external device 1 Slide ( ) towards AUX to select Aux-in audio source. »»The power indicator( ) turns white. 2 Connect your speaker with an external device throught the supplied USB cable. 3 Start music play on your device.
Specifications Amplifier Rated Output Power 2W RMS Signal to Noise Ratio >70dB Aux-in Link 600 mV RMS, 10 kohm Bluetooth Bluetooth specification V2.1+EDR Supported Profiles HFPv1.6, A2DPv1.2, HSPv1.2 Advanced features Echo and noise cancellations Range 10 m/33 feet line of sight General information DC power input USB: 5V, 500mA; Built-in Li-Polymer battery 3.7V 500mAH Battery working time >8 hours Dimensions-Main Unit (diameter x height) D68mm * H81mm Weight- Main Unit 0.
6 Troubleshooting Warning •• Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/support). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. No power •• Recharge your speaker.
2014 © WOOX Innovations Limited. All rights reserved. Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used by WOOX Innovations Limited under license from Koninklijke Philips N.V. SBT30_00_UM_V3.
