Register your product and get support at www.philips.
a b c d e f g
BEEP PHILIPS SBT30
1 Important Safety Important Safety Instructions a b c d e f g h i j k l Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
Warning •• Never remove the casing of this apparatus. •• Never lubricate any part of this apparatus. •• Never place this apparatus on other electrical equipment. Notice Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. Notice for the USA and Canada This device complies with Part 15 of the FCC Rules and RSS standard of Industry Canada.
• • • Increase the separation between equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. RF Radiation Exposure Statement: This equipment complies with FCC’s and IC’s RF radiation exposure limits set forth for an uncontrolled environment.
All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.) Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.
3 Get started Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. Write the numbers here: Model No. __________________________ Serial No. ___________________________ Power supply The speaker can operate on built-in rechargeable battery. To recharge the built-in battery: Connect micro USB socket( ) with PC through supplied USB cable.
1 Slide ( ) towards to select Bluetooth audio source. »»The Bluetooth indicator( ) flashes.(Blue) 2 Activate the Bluetooth function in your Bluetooth device. 3 Select “PHILIPS SBT30” on your Bluetooth device for pairing. »»The speaker beeps twice and the Bluetooth indicator( ) stays steadily on.(Blue) • For some devices, you may need to input “0000” as pairing password. 4 Start music play on your Bluetooth device. When there is an incoming call: • Press Bluetooth button( ) to pick up the call.
5 Product information Note •• Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 2W RMS Signal to Noise Ratio >70dB Aux-in Link 600 mV RMS, 10 kohm Bluetooth Bluetooth specification V2.1+EDR Supported Profiles HFPv1.6, AD2Pv1.2, HSPv1.
Built-in Li-Polymer battery 3.7V 500mAH Battery working time >8 hours Dimensions-Main Unit (diameter x height) D68mm * H81mm Weight- Main Unit 0.14 kg 6 Troubleshooting Warning •• Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/welcome).
All registered and unregistered trademarks are property of their respective owners. © 2012 Koninklijke Philips Electronics N.V. All rights reserved. SBT30_37_UM_V1.
