User manual
36
5. Szabályozási információk
5. Szabályozási információk
CE Declaration of Conformity
This product is in conformity with the following
standards
• EN60950-1:2006+A11:2009+A1:20
10+A12:2011(Safetyrequirementof
Information Technology Equipment).
• EN55022:2010(RadioDisturbance
requirement of Information Technology
Equipment).
• EN55024:2010(Immunityrequirementof
Information Technology Equipment).
• EN61000-3-2:2006+A1:2009+A2:2009
(LimitsforHarmonicCurrentEmission).
• EN61000-3-3:2008(LimitationofVoltage
Fluctuation and Flicker) following provisions
of directives applicable.
• 2006/95/EC(LowVoltageDirective).
• 2004/108/EC(EMCDirective).
• 2009/125/EC(ErP,Energy-relatedProduct
Directive,ECNo.1275/2008and642/2009
Implementing)
• 2011/65/EU(RoHSDirective)
And is produced by a manufacturing
organizationonISO9000level.
The product also comply with the following
standards
• ISO9241-307:2008(Ergonomic
requirement, Analysis and compliance test
methods for electronic visual displays).
• GSEK1-2000:2013(GSmarkrequirement).
• prEN50279:1998(LowFrequencyElectric
andMagneticfieldsforVisualDisplay).
• MPR-II(MPR:1990:8/1990:10Low
Frequency Electric and Magnetic fields).
EN55022Compliance(CzechRepublicOnly)
PolishCenterforTestingandCertication
Notice
The equipment should draw power from a
socket with an attached protection circuit (a
three-prongsocket).Allequipmentthatworks
together (computer, monitor, printer, and so on)
should have the same power supply source.
The phasing conductor of the room's electrical
installationshouldhaveareserveshort-circuit
protection device in the form of a fuse with a
nominal value no larger than 16 amperes (A).
To completely switch off the equipment, the
power supply cable must be removed from the
power supply socket, which should be located
near the equipment and easily accessible.
Aprotectionmark"B"conrmsthatthe
equipment is in compliance with the protection
usagerequirementsofstandardsPN-93/T-42107
andPN-89/E-06251.