User manual
Table Of Contents
- Contents
- General description
- Introduction - Identify your shaver
- Fig. A
- Fig. B
- Important safety information
- What do the icons on the display mean? (Fig. A)
- What do the icons on the display mean? (Fig. B)
- Main menu (Fig. A)
- Main menu (Fig. B)
- How do I connect my shaver and smartphone? (Fig. A)
- How do I connect my shaver and smartphone? (Fig. B)
- What is my shaver telling me? (Fig. A)
- What is my shaver telling me? (Fig. B)
- How do I charge my appliance?
- How do I use my appliance and the attachments?
- How do I clean my appliance and the attachments?
- Storage
- How do I replace the shaving heads?
- Ordering accessories
- Troubleshooting
- Further guidance
- Recycling
- Trademarks
41
English
Cleaning the beard styler attachment
Clean the beard styler attachment after each use.
1
Pull the comb off the beard styler attachment.
Note: Grab the comb in the center to pull it off the
beard styler attachment. Do not pull at the sides of
the comb.
2
Rinse the cut hairs off the cutting unit with lukewarm
water.
3
Rinse the cut hairs off the comb.
4
Remove the cutting unit from the beard styler
attachment. By pushing the cutting unit from the
beard styler attachment you can remove any hairs
that have accumulated inside the beard styler. You
can also rinse the back of the cutting unit.
5
Rinse cut hairs out of the beard styler attachment.
6
Carefully shake off excess water and leave the comb,
cutting unit and beard styler attachment to air-dry
before next use.
Never dry the cutting unit with a towel or tissue, as
this may damage the trimming teeth.
7
When the cutting unit is dry attach it to the beard
styler attachment.