User manual
Table Of Contents
- Contents
- General description
- Introduction - Identify your shaver
- Fig. A
- Fig. B
- Important safety information
- What do the icons on the display mean? (Fig. A)
- What do the icons on the display mean? (Fig. B)
- Main menu (Fig. A)
- Main menu (Fig. B)
- How do I connect my shaver and smartphone? (Fig. A)
- How do I connect my shaver and smartphone? (Fig. B)
- What is my shaver telling me? (Fig. A)
- What is my shaver telling me? (Fig. B)
- How do I charge my appliance?
- How do I use my appliance and the attachments?
- How do I clean my appliance and the attachments?
- Storage
- How do I replace the shaving heads?
- Ordering accessories
- Troubleshooting
- Further guidance
- Recycling
- Trademarks
36
English
2
Slide the comb straight into the guiding grooves on
both sides of the beard styler attachment.
3
Press the length selector and then push it to the left or
right to select the desired hair length setting.
4
Switch on the appliance.
5
Move the appliance upwards while you exert gentle
pressure. Make sure the front of the comb is in full
contact with the skin.
6
Switch off the appliance and clean the attachment
after use.
Using the beard styler attachment without comb
You can use the beard styler attachment without the
comb to contour your beard, moustache, sideburns or
neckline to a length of 0.5mm.
1
Pull the comb off the beard styler attachment.
Note: Grab the comb in the center to pull it off the
beard styler attachment. Do not pull at the sides of
the comb.
2
Switch on the appliance.
3
Hold the beard styler attachment perpendicular to the
skin and move the appliance downwards while you
exert gentle pressure.
4
Switch off the appliance and clean the attachment
after use.
Using the cleansing brush attachment
Use the cleansing brush with your daily cleansing cream
to remove oil and dirt.
We advise you to use it no more than once a week.