User manual
Table Of Contents
- Contents
- General description
- Introduction - Identify your shaver
- Fig. A
- Fig. B
- Important safety information
- What do the icons on the display mean? (Fig. A)
- What do the icons on the display mean? (Fig. B)
- Main menu (Fig. A)
- Main menu (Fig. B)
- How do I connect my shaver and smartphone? (Fig. A)
- How do I connect my shaver and smartphone? (Fig. B)
- What is my shaver telling me? (Fig. A)
- What is my shaver telling me? (Fig. B)
- How do I charge my appliance?
- How do I use my appliance and the attachments?
- How do I clean my appliance and the attachments?
- Storage
- How do I replace the shaving heads?
- Ordering accessories
- Troubleshooting
- Further guidance
- Recycling
- Trademarks
49
English
Problem Possible cause Solution
The shaving unit is
soiled or damaged
to such an extent
that the motor
cannot run.
Clean the shaving heads
thoroughly or replace them.
Theappliance
doesnot shave as
well as it used to.
The shaving heads
are damaged or
worn.
Replace the shaving heads (see
'Replacing the shaving heads').
Hairs or dirt
obstruct the
shaving heads.
Clean the shaving heads
thoroughly (see 'Thorough
cleaning').
Water is leaking
from the bottom of
the appliance.
During cleaning,
water may collect
between the inner
body and the outer
shell of the
appliance.
This is normal and not dangerous
because all electronics are
enclosed in a sealed power unit
inside the appliance.
Philips Quick Clean Pod
Problem Possible cause Solution
My shaver isn't clean
after using the Philips
Quick Clean Pod.
You removed the shaver
before the cleaning
program was finished.
Leave the shaver in the
Philips Quick Clean Pod
for the full cleaning
program. Each cleaning
program takes
approximately 1 minute.
The cleaning icon goes
out when the cleaning
program is finished.
The Philips Quick Clean
Pod Cartridge needs to
be replaced.
Replace the Philips
Quick Clean Pod
Cartridge.
The Philips Quick Clean
Pod is tilted.
Place the Philips Quick
Clean Pod on a flat
surface.