User manual

ENGLISH
removed from the cleaning cartridge (see
‘Preparing SmartClean System For Use’).
C 4 Shake off any excess water from shaver
before placing in the SmartClean System.
C 5 Hold the shaver head side down above the
shaver holder.
C 6 Place the shaver into the holder (1), push
shaver back (2) and press down the top
cap to connect the shaver (3) (click).
The shaver will only fit in the SmartClean System
in one direction.
7 The battery symbol slowly blinks to
indicate shaver is charging.
C 8 Press the ON/OFF button on the
SmartClean System to start the cleaning
cycle. (click).
The cleaning symbol will blink.
The cleaning cycle takes approximately 10
minutes. When completed, the cleaning
symbol will light up continuously and the
drying phase starts automatically.
29
ENGLISH
C 5 While holding the SmartClean System with
one hand, gently push the top part of the
SmartClean System back down. You will
hear a 'click'.
When the SmartClean System is ready for use,
do not move appliance to prevent leakage.
Cleaning the Shaver in the
SmartClean System
C SmartClean System has two phases: a cleaning
phase and a drying phase.
If the shaver does not contain enough power
for one (1) shave, the SmartClean System
may not work properly. Charge the shaver
in the
SmartClean System
before using the
SmartClean System to clean your shaver.
If you use the shaver with shaving foam or gel,
quickly rinse under hot water before cleaning
in the SmartClean System.
1 Connect the small plug to the
SmartClean
System
. Connect the power plug into any
100V to 240V AC outlet. Use only the
power cord provided.
C 2 Press the top cap to open the SmartClean
System.
3. Place the SmartClean System on a flat,
level surface. Make sure the seal has been
28
1
2
3