Important Information Manual

- Always check the appliance
before you use it. Do not use
the appliance if it is damaged,
as this may cause injury.
Always replace a damaged
part with one of the original
type.
- Do not open the appliance to
replace the rechargeable
battery.
- This appliance contains
batteries that are non-
replaceable.
Caution
- Never use water hotter than
60°C to rinse the shaver.
- Only use this appliance for its
intended purpose as shown
in the user manual.
- For hygienic reasons, the
appliance should only be
used by one person.
- Never use compressed air,
scouring pads, abrasive
cleaning agents or aggressive
liquids such as petrol or
acetone to clean the
appliance.
- Water may drip from the
socket at the bottom of the
shaver when you rinse it. This
is normal and not dangerous
because all electronics are
enclosed in a sealed power
unit inside the shaver.
- Do not use the supply unit in
or near wall sockets that
contain an electric air
freshener to prevent
irreparable damage to the
supply unit.
- Be careful when handling
your smartphone near water
and in moist environments.
- The shortwave radio
frequency signals of a
Bluetooth® appliance may
impair the operation of other
electronic and medical
devices.
- Switch off Bluetooth where it
is prohibited.
- Do not use the appliance in
medical facilities, aircraft,
refuelling points, close to
automatic doors, automatic
fire alarms or other
automatically controlled
devices.
- Keep this appliance at least
20 cm from pacemakers and
other medical devices. Radio
waves may impair the
operation of pacemakers and
other medical devices.
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable
standards and regulations regarding exposure to
electromagnetic fields.
Radio Equipment Directive
- The frequency band in which the appliance
operates is 2.4 GHz.
- This appliance is equipped with Bluetooth class
2
- The maximum radio frequency power radiated
in the frequency band in which the appliance
operates is less than 20 dBm.
- This equipment has been so constructed that
the product complies with the requirement of
Article 10(2) as it can be operated in at least one
EU Member State as examined and the product
is compliant with Article 10(10) as it has no
restrictions on putting into service in all EU
member states.