User manual

English
Charging in the charging stand (specic models only)
1 Make sure the appliance is switched o.
2 Put the small plug in the charging stand and
put the supply unit in the wall socket.
3 Place the appliance in the charging stand.
Specic models only: The light ring on the
bottom of the charging stand lights up and
rotates quickly.
- After approximately 5 minutes, the light
ring rotates slower. The battery now
contains enough energy for one full shave.
- As the appliance continues to charge, the
light ring becomes brighter and rotates
slower.
- When the appliance is fully charged, the
light ring lights up fully and stops rotating.
4 After charging, remove the supply unit from
the wall socket and pull the small plug out of
the charging stand.
'Unplug for use' symbol
The 'unplug for use' symbol ashes to remind
you to disconnect the appliance from the wall
socket and remove the small plug from the
appliance before you switch it on.
How do I use my appliance and the attachments?
Warning: Always check the appliance and
all accessories before use. Do not use the
appliance or any accessory if it is damaged,
as this may cause injury. Always replace a
damaged part with one of the original type.
Note: This appliance is waterproof. It is suitable
for use in the bath or shower and for cleaning
under the tap.
38