Register your product and get support at www.philips.
1 2 English Contents Notice 2 Compliance 2 Important 2 Disposal of your old product 3 Connect 3 3 3 4 4 Place the wireless receiver Connect the wireless transmitter Connect rear speakers to wireless receiver Connect power cord 3 Troubleshooting 5 4 Product specifications 5 EN 1
1 Notice Philips Modelo: RWSS5510, RWSS9500 Compliance Agência Nacional de Telecomunicações This product is in compliance with the essential requirements and other relevant provisions of Directives 2006/95/EC (Low Voltage), 2004/108/ EC (EMC). Hereby, Philips Consumer Lifestyle, declares that this Wireless Rear Audio System RWSS5510, RWSS9500 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.
2 Connect English Risk of injury or damage to the product! •• Never place the product or any objects on power cords or on other electrical equipment. •• If the product is transported in temperatures below 5°C, unpack the product and wait until its temperature matches room temperature before connecting it to the power outlet. Risk of overheating! •• Never install this product in a confined space. Always leave a space of at least four inches around the product for ventilation.
Connect rear speakers to wireless receiver For RWSS9500 REAR RIGHT REAR LEFT Note •• The rear speakers in the picture shown may vary. ~AC MAINS For RWSS5510 REAR LEFT REAR RIGHT REAR REAR RIGHT LEFT ~AC MAINS REAR LEFT REAR RIGHT Connect the rear left and rear right speakers to the matching connectors at the back of the wireless receiver.
Troubleshooting Follow these steps within twenty seconds if there is no sound from the rear speakers and the indicator on the wireless receiver blinks continuously for more than one minute. For home theater with Blu-ray Disconnect the power cord from the wireless receiver for a few seconds and connect it back again. Switch to either AUX source or MP3 link source. Press and hold the Navigation button, (right) for three seconds. »» ‘PAIRING’ blinks and then ‘PAIRED’ is displayed.
© 2011 Koninklijke Philips Electronics N.V. All rights reserved. sgptt_1103/00_v4 book1 back page.
