User manual
Note: Before you use the shaver for the rst time, remove the protective foil from the display.
The four shaver types (RQ1290, RQ1280, RQ1260 and RQ1250) have different displays, which are shown in the gures below.
- RQ1290/RQ1280 (Fig. 4)
- RQ1260 (Fig. 5)
- RQ1250 (Fig. 6)
- Charging takes approx. 1 hour.
- When the shaver is charging, the minutes indication ashes (Fig. 7).
- The shaving minutes increase until the shaver is fully charged.
- Quick charge: When the shaver contains enough energy for one shave, the display shows 5 minutes in red.
- When the shaver is charging, rst the bottom charging light ashes, then the second charging light, and so on until the shaver is fully
charged (Fig. 8).
Note: The displays of types RQ1260 and RQ1250 look different, but the charging lights work in the same way.
- Quick charge: When the shaver contains enough energy for one shave, the bottom charging light alternately ashes orange and white.
- When the battery is fully charged, the minutes indication lights up continuously. After approx. 30 minutes the display automatically switches
off again (Fig. 9).
- When the battery is fully charged, all charging lights light up continuously. After approx. 30 minutes the display automatically switches off
again. (Fig. 10)
Note: The displays of types RQ1260 and RQ1250 look different, but the charging lights work in the same way.
- When the battery is almost empty (when there are only 5 or fewer shaving minutes left), the minutes indication starts to ash (Fig. 11).
- When you switch off the shaver, the shaving minutes continue to ash for a few more seconds. You hear a beep when there are no shaving
minutes left.
- When the battery is almost empty (when there are only 5 or fewer shaving minutes left), the bottom charging light ashes orange. (Fig. 12)
- When you switch off the shaver, the bottom charging light continues to ash orange for a few seconds.
Note: The displays of types RQ1260 and RQ1250 look different, but the charging lights work in the same way.
- The remaining battery capacity is indicated by the number of shaving minutes shown on the display. (Fig. 7)
- The remaining battery capacity is indicated by the ashing charging lights (Fig. 8).
Note: The displays of types RQ1260 and RQ1250 look different, but the charging lights work in the same way.
For optimal shaving performance, we advise you to clean the shaver after every use.
- The tap symbol ashes to remind you to clean the shaver (Fig. 13).
Note: The displays of types RQ1290, RQ1280, RQ1260 and RQ1250 look different, but show the same symbol.
For maximum shaving performance, we advise you to replace the shaving unit every year.
- To remind you to replace the shaving unit, the shaving unit symbol ashes (all types) and you hear a beep when you switch off the shaver
(RQ1290/RQ1280 only). This happens at the end of 7 successive shaves. (Fig. 14)
Note: The displays of types RQ1290, RQ1280, RQ1260 and RQ1250 look different, but show the same symbol.
You can lock the shaver when you are going to travel. The travel lock prevents the shaver from being switched on by accident.
1 Press the on/off button for 3 seconds to enter the travel lock mode (Fig. 15).
, RQ1280: The display starts to count down from 3. At 1, the appliance beeps to indicate that it is locked.
, The lock symbol lights up on the display. After a few seconds it goes out.
Note: The displays of types RQ1280, RQ1260 and RQ1250 look different, but show the same symbol.
1 Press the on/off button for 3 seconds.
, The motor starts running to indicate that the travel lock has been deactivated.
The shaver is now ready for use again.
7