User manual
1 Remove the shaver from the Power Pod or the Jet Clean System.
2 Let the shaver run until it stops.
3 Pull the shaving unit off the shaver.
4 Undo the 2 screws on the back of the shaver. (Fig. 46)
5 Insert a screwdriver between the front and back panel to open
the shaver. (Fig. 47)
6 Remove the side panels (Fig. 48).
7 Unscrew the 3 screws on the inside of the shaver and remove the
back cover (Fig. 49).
8 Pull the wires out of the motor unit and remove the
battery (Fig. 50).
Be careful, the battery strips are sharp.
Do not put the shaver back into the plugged-in Power Pod or Jet Clean
System after you have removed the battery.
Guarantee & service
If you need service or information or if you have a problem, please visit
the Philips website at www.philips.com or contact the Philips Consumer
Care Centre in your country (you nd its phone number in the
worldwide guarantee leaet). If there is no Consumer Care Centre in
your country, go to your local Philips dealer.
Guarantee restrictions
The shaving heads (cutters and guards) are not covered by the terms of
the international guarantee because they are subject to wear.
1
Why doesn’t the shaver shave as well as it used to?
The Jet Clean System may not have cleaned the shaver properly,
because the cleaning uid in the cleaning chamber is soiled or the
-
ENGLISH 19