User manual

A fully charged shaver has a shaving time of up to 65 minutes, which is
enough for approx. 21 shaves.
The actual shaving time is calculated by the shaver. If you have a heavy
beard, the shaving time may be less than 65 minutes. The shaving time
may also vary over time, depending on your shaving behaviour and beard
type.

After the shaver has charged for 5 minutes, it contains enough energy for
one shave.
Charging in the Power Pod
1 Put the small plug in the Power Pod (Fig. 21).
2 Put the adapter in the wall socket.
3 Pull at the top of the lid (1) and remove it (2) (Fig. 22).
4 First insert the top of the shaver into the Power Pod (1) and then
press the bottom part into the Power Pod (2) (Fig. 23).
Note: The shaver cannot be placed in the Power Pod when the protection cap
is on the shaving unit.
The display shows that the shaver is charging (see chapter ‘The
display’).

1 Put the small plug in the Jet Clean System.
2 Put the adapter in the wall socket.
3 Place the shaver upside down in the holder with the display
pointing towards the front of the Jet Clean System (Fig. 24).
Note: RQ1090,RQ1062,RQ1060 only: when you turn the shaver upside
down, the indications on the display are also turned upside down so you can
still see the remaining battery capacity.
4 Press the shaver tightly into the holder to lock it into place (Fig. 25).
,
ENGLISH12