User manual


- If the shaving heads are blocked, the shaving unit symbol and the tap
symbol with exclamation mark ash. In this case, the motor cannot
run because the shaving heads are soiled or damaged. (Fig. 19)
Note: The displays of types RQ1062, RQ1060, RQ1052 and RQ1050 look
different but show the same indication.
- When this happens, you have to clean the shaving unit or replace it.
- The shaving unit symbol and the tap symbol with exclamation mark
continue to ash until you unblock the shaving heads.
Charging
Charging takes approx. 1 hour.
A fully charged shaver has a shaving time of up to 65 minutes, which is
enough for approx. 21 shaves.
The actual shaving time is calculated by the shaver. If you have a heavy
beard, the shaving time may be less than 65 minutes. The shaving time
may also vary over time, depending on your shaving behaviour and beard
type.

After the shaver has charged for 5 minutes, it contains enough energy for
one shave.
1 Put the small plug in the Power Pod (Fig. 20).
2 Put the adapter in the wall socket.
3 Pull at the top of the lid (1) and remove it (2) (Fig. 21).
4 First insert the top of the shaver into the Power Pod (1) and then
press the bottom part into the Power Pod (2) (Fig. 22).
Note: The shaver cannot be placed in the Power Pod when the protection cap
is on the shaving unit.
, The display shows that the shaver is charging (see chapter ‘The
display’).
ENGLISH 11