Operating instructions

• 19 •
English
9 CLEANING
Maintenance and cleaning may only be carried out when the
machine has cooled down and has been disconnected from the
power supply.
• Do not immerse the machine in water nor place any of its
parts in a dishwasher.
• Do not use spirit, solvents and/or aggressive chemical
agents.
• We recommend cleaning the water tank and  lling it up with
fresh water daily.
• (Fig.21-22) - Every day, after heating the milk, remove the
external part of the Pannarello and wash it with fresh drink-
ing water.
• (Fig.23) - Clean the steam spout weekly. In order to do this,
please:
- Remove the external part of the Pannarello (for standard
cleaning).
- Loosen the ring nut (without removing it).
- Remove the upper part of the Pannarello from the steam
spout.
- Wash the upper part of the Pannarello with fresh drinking
water.
- Wash the steam spout with a wet cloth and remove any
milk residue.
- Replace the upper part of the steam spout (make sure it is
completely inserted).
- Tighten the previously loosened ring nut.
Reassemble the external part of the Pannarello.
• (Fig.24) - Empty and clean the drip tray daily
• Use a damp and soft cloth to clean the appliance.
• (Fig.17) - Perform the following operations to clean the
pressurized porta lter:
- (Fig.10) - Remove the  lter, wash it thoroughly with hot
water.
- Remove the adapter (if  tted), and wash it thoroughly with
hot water.
- Wash the internal part of the pressurized porta lter.
• Do not dry the machine and/or its components in a micro-
wave and/or in a conventional oven.
Note: do not wash the pressurized porta lter in
the dishwasher.
10 DESCALING
The formation of limescale inside the appliance is inevitable.
It is necessary to descale the machine every 1-2 months of use
and/or when you notice a reduction in the water delivery. Use
the Saeco descaling product only.
In case of con ict, priority must be given to
what is indicated in the operation and mainte-
nance manual over the instructions provided on sepa-
rately sold accessories and materials.
Use the Saeco descaling product (Fig. B). Its for-
mula has been designed to ensure better ma-
chine performance and operation for its whole operat-
ing life. If correctly used, it also avoids alterations in the
brewed product. Before starting a descaling cycle make
sure that: THE WATER FILTER (if used) HAS BEEN REMOVED.
Never drink the descaling solution or any prod-
ucts dispensed until the cycle has  nished.
Never use vinegar as a descaling solution.
1 (Fig.11-12) - Insert the porta lter into the brew unit from
the bottom (6) and turn it from left to right until it locks into
place.
2 (Fig.1) - Remove and empty the water tank.
3 (Fig.2) - Pour HALF the content of the Saeco concentrated
descaling solution into the water tank, then  ll the tank with
fresh drinking water up to the MAX level.
4 (Fig.2) - Switch on the machine by pressing the ON/OFF but-
ton (2).
(Fig.4) - Fill up (as described in Section 7 of the manual) two
cups of water (about 150 ml each) from the steam / hot wa-
ter wand and turn o the machine by pressing the ON/OFF
button (2).
5 Leave the descaling solution to descale for approx.15-20
minutes with the machine turned o .
6 Switch on the machine by pressing the ON/OFF button (2).
(Fig.4) - Fill up (as described in Section 7 of the manual) two
cups of water (about 150 ml each) from the steam / hot wa-
ter wand. Then turn the machine o by means of the ON/OFF
button (2) and leave it o for 3 minutes.
7 Repeat the operations as described in step 6 until the water
tank is completely empty.
8 (Fig.2) - Rinse the water tank with fresh drinking water and
 ll it completely.
9 Place a container under the porta lter.
10 (Fig.6) - Switch on the machine by pressing the ON/OFF but-
ton (2); turn the selection knob (17) to the “
” position
and, using the porta lter, dispense the whole content of the
tank. Switch the selection knob (17) to the “
” position to
stop the dispensing.
11 (Fig.2) - Fill the tank again with fresh water.
(Fig.4) - Place a large enough container under the steam
wand. Open the water dispensing knob (4) by turning it
counter-clockwise. Turn the selection knob (17) to the “
”
position and dispense the whole content of the tank by means