Operating instructions

• 17 •
English
4.7 Drip Tray Adjustment
The drip tray can be adjusted according to the cup size.
To adjust the drip tray height, do as follows.
• (Fig.24) - Lift the drip tray and remove the grill.
• (Fig.25) - Remove the support under the drip tray.
• (Fig.26 - 27) - Rotate the support and place it in the co ee
machine.
• (Fig.28) - Put the drip tray on the support and replace the
grill.
5 COFFEE BREWING
Warning! During the co ee brewing, do not re-
move the pressurized porta lter by manually
turning it clockwise. Danger of burns.
• During this operation, the "machine ready" light (15) may
 ash; this is to be considered a standard and not a faulty
operating mode.
• Before using the machine, make sure that the hot water/
steam knob (4) is closed and that there is enough water in
the tank.
• (Fig.3) - Press the ON/OFF button (2).
• Wait until the "machine ready" light (15) turns on. The ma-
chine is now ready for co ee brewing.
5.1 Using Ground Coff ee
• (Fig.8) - Insert the  lter (11) in the pressurized porta lter
(10); the  lter is already inserted before using the machine
for the  rst time.
• (Fig.11) - Insert the porta lter into the brew unit from the
bottom (6).
• (Fig.12) - Turn the porta lter from left to right until it locks
into place. Release the porta lter grip. The handle will
slightly turn to the left. This movement guarantees porta l-
ter performance.
• (Fig. 14) - Preheat the pressurized porta lter by switching
the selection knob (17) to the "
" position until some
water spills out of it. This is to be done only for the  rst co ee
brewing.
• When 150cc of water have  owed out, switch the selection
knob (17) to the "
" position in order to stop brewing.
• (Fig.16) - Remove the porta lter from the machine by turn-
ing it from right to left and drain any water left. There is no
need to change the  lter to make one or two co ees, since
the machine is equipped with a special  lter (11).
• (Fig.9A) - Add 1- 1.5 measuring scoop for single co ee and
2 measuring scoops for double co ee. Remove any co ee
residues from the rim of the  lter.
• (Fig.11) - Insert the porta lter (10) into the brew unit from
the bottom (6).
• (Fig.12) - Turn the porta lter from left to right until it locks
in place.
• (Fig.13) - Take 1 or 2 preheated cups and place them
under the pressurized porta lter. Make sure that they are
correctly placed under the co ee dispensing holes.
• (Fig.14) - Turn the selection knob (17) to the "
" posi-
tion.
• When the desired quantity of co ee has been obtained,
turn the selection knob (17) to the "
" position in order
to stop co ee brewing. Wait a few second after brewing has
stopped, then remove the cups of co ee (Fig. 15).
• (Fig.16) - Remove the pressurized porta lter and empty the
remaining co ee residues.
Note: If a small quantity of water remains in the
porta lter, this is absolutely normal and is due
to the porta lter features.
Important note: The  lter (11) should be kept
clean to guarantee perfect results. Clean daily
after use.
5.2 Using Coff ee Pods
• (Fig.10) - Use a co ee spoon to remove the  lter for ground
co ee (11) from the pressurized porta lter (10).
• (Fig.7A) - Insert the co ee pod adapter (13) - with the con-
vex part facing down - into the pressurized porta lter (10).
• (Fig.7B) - Then, insert the pod  lter (14) into the pressur-
ized porta lter (10).
• (Fig.11) - Insert the pressurized porta lter into the brew
unit (6) from the bottom.
• (Fig.12) - Turn the porta lter from left to right until it locks
into place. Release the grip from the pressurized porta lter.
The handle is automatically slightly turned leftwards.
This movement guarantees porta lter performance.
• (Fig. 14) - Preheat the pressurized porta lter by switching
the selection knob (17) to the "
" position until some
water spills out of it. This is to be done only for the  rst co ee
brewing.
• When 150cc of water have  owed out, switch the selection
knob (17) to the "
" position in order to stop hot water dis-
pensing.
• (Fig.16) - Remove the pressurized porta lter from the ma-
chine by turning it from right to left. Be careful not to remove
the  lter.
• (Fig.9B) - Insert the pod into the porta lter and make sure
the paper of the pod does not overhang the porta lter.
• (Fig.11) - Insert the porta lter into the brew unit from the
bottom (6).
• (Fig.12) - Turn the porta lter from left to right until it locks
in place.
• Take 1 preheated cup and place it under the porta lter;
make sure that it is correctly placed under the co ee dis-
pensing holes.
• (Fig.14) - Turn the selection knob (17) to the "
" posi-
tion.
• When the desired quantity of co ee has been obtained, turn
the selection knob (17) to the "
" position in order to stop