Specifications

– 46 –
S YMPTOM D IAGNOSIS R EMEDY
NO CONN
(Communication Error)
8-pin DIN cable is
disconnected from the
CDX mechanism or
source unit
Check the connection of 8-pin DIN
cable between the CDX and unit
CD Changer does
not operate
CDX cable is intermittent
or severely damaged
Check connections and repair or
replace CDX cable as necessary
CDX cable is disconnect-
ed from the Source Unit
or CD Changer
Check connections at the Source unit
and CD Changer and repair wiring as
necessary
Communication issue
Press Reset on CD Changer
Disc is jammed in
the CD Changer
Disc load/unload prob-
lem
Press Reset on CD Changer. If CD
Changer still does not operate, see
your Local Authorized Rockford
Fosgate Dealer
IR Remote has
poor range
Batteries are weak
Check battery condition and replace
as necessary with (1) CR2025 (+3 volt)
battery
Excessive dirt or dust on
IR Remote transmitter
lens
Clean transmitter lens with Plexiglas
solution and a non-abrasive cloth as
necessary
Excessive dirt or dust on
source unit receiver lens
Clean receiver lens (compact disc
logo) with Plexiglas solution and a
non-abrasive cloth as necessary
IR remote is outside of
optimum transmitting
range
Operate IR remote within about 15 ft
and ±45˚ from horizontal of the
Source unit’s faceplate
High sunlight conditions
Operate IR remote closer to Source
Unit
IR Remote does
not work
(LED does not
illuminate)
Batteries are dead
Check battery condition and replace
as necessary with (1) CR2025 (+3 volt)
battery
Battery is installed incor-
rectly
Check battery installation and repair
as necessary (polarity is indicated on
pc board)
S YMPTOM D IAGNOSIS R EMEDY
IR R EMOTE T ROUBLESHOOTING