Specifications

– 43 –
ERROR 6
(Transverse Error)
Transverse motor or
switch is defective.
Traverse area damaged
Check CD mechanism motor, switch
and transverse area.
S YMPTOM D IAGNOSIS R EMEDY
Disc will not eject
(also see error codes)
Voltage applied to Yellow
wire is not between 10.8
and 16 volts or there is
no voltage present
Check battery, connections and fuses,
and repair or replace as necessary. If
voltage is above +16 volts, have the
electrical system inspected by an
authorized car service center
ERROR 1
(Initialize Error)
No initialization
Press the reset button
Mechanism is jammed
and loading motor (or
driving circuit) is defec-
tive
Repair the mechanism and
loading motor (or driving circuit)
ERROR 3
(Loading Error)
Foreign objects are pre-
venting the disc from
loading
Check CDP mechanism load area by
removing faceplate and repair as nec-
essary
Loading area in mechanism
and loading motor (or dri-
ving circuit) is defective
Repair the mechanism and loading
motor (or driving circuit)
ERROR 4
(Eject Error)
Foreign objects are pre-
venting disc from ejecting
Check CDP mechanism eject area by
removing faceplate and repair as nec-
essary
Eject area in mechanism
and ejecting motor (or dri-
ving circuit) is defective
Repair the mechanism and loading
motor (or driving circuit)
ERROR 7
(Servo Error)
Excessive dirt or dust on
disc
Clean disc to remove dirt or dust as
necessary
Disc is warped cracked or
severely damaged
Put in a different disc!
Excessive scratches on
disk
Put in a different disc!
ERROR 9
(TOC Error)
Disc is cracked, warped or
severely damaged
Put in a different disc!
Laser pickup is defective Have service center repair laser pickup
Servo unit in CDP mech-
anism is not operating
properly
Check the servo circuit area and
repair as necessary