Specifications

– 14 –
I NSTALLING THE S OURCE U NIT – ISO-DIN M OUNT
• Remove Trim Piece and Installation Sleeve from source unit.
• Factory Bracket should align with two mounting holes on each side of
source unit.
• ISO Screws should be 6mm max (use supplied screws).
• Connect Antenna to antenna jack on rear of source unit.
• Install Source Unit into instrument panel.
U NINSTALLING THE S OURCE U NIT – S TANDARD M OUNT
• Disconnect Back strap from rear of radio (if used).
• Insert Release Keys into left and right sides of source unit to disengage locks.
• Remove Source Unit from installation sleeve with release keys.