User manual

Cleaning the shaving unit in the Jet Clean
System (PT920CC only)
The Jet Clean System cleans the shaving unit.
Preparing the Jet Clean System for use
Note: Fill the cleaning chamber before rst use and
when the ‘uid low’ symbol ashes to indicate that the
uid level is too low. When the uid level drops below
the minimum level, the cleaning symbol and the ‘uid
low’ symbol start to ash and the shaver holder returns
to its starting position
1 Simultaneously press the release buttons
on both sides of the cleaning chamber (A).
Then lift the Jet Clean System off the cleaning
chamber (B).
, The cleaning chamber remains behind.
2 Unscrew the cap from the bottle with Jet
Clean solution (HQ200) and remove the
airtight seal.
3 Fill the cleaning chamber with Jet Clean
solution (HQ200) up to the MAX indication.
Note: Make sure the cleaning chamber is always lled
above the MIN indication.
4 Place the Jet Clean System back onto the
cleaning chamber (‘click’).
Make sure that the release buttons snap back into
place.
When the cleaning chamber is lled with Jet Clean
solution, do not move it to prevent leakage.
5 Put the small plug in the Jet Clean System and
put the adapter in the wall socket.
ENGLISH 17