User manual

22
Always put the protection cap on the shaver
to protect the shaving heads when you are
travelling.
Compliance with standards
The shaver complies with the internationally
approved IEC safety regulations and can be safely
cleaned under the tap.
The shaver complies with all standards regarding
electromagnetic elds (EMF). If handled properly
and according to the instructions in this user
manual, they are safe to use based on scientic
evidence available today.
General
The appliance is equipped with an automatic
voltage selector and is suitable for mains voltages
ranging from 100 to 240 volts.
The adapter transforms 100-240 volts to a safe
low voltage of less than 24 volts.
Charging
PT860: It takes approx. 1 hour to fully charge the
shaver.
PT735/PT730/PT725/PT720: It takes approx. 8 hours
to fully charge the shaver.
When you charge the shaver for the rst time or
after a long period of disuse, let it charge until the
charging light lights up continuously.
A fully charged shaver provides up to 17 (PT860) or
14 (PT735/PT730/PT725/PT720) cordless shaves.
The shaving time may be less than 17 (PT860) or
14 (PT735/PT730/PT725/PT720) cordless shaves
as a result of your shaving behaviour, your cleaning
habits or your beard type.
-
-
-
-
-
ENGLISH8
Charge indications
Battery low
When the battery is almost empty (when there
are only 5 or fewer shaving minutes left), the
charging light starts to ash orange.
When you switch off the shaver, the charging light
continues to ash orange for a few seconds.
Quick charging
When you start charging the empty battery,
the charging light alternately ashes orange and
green. After approx. 3 minutes, the charging light
continues to ash green. The shaver now contains
enough energy for a 5-minute shave.
Charging
When the shaver is charging, the charging light
ashes green.
Battery fully charged
When the battery is fully charged, the charging
light lights up green continuously.
Note: After approx. 30 minutes, the charging light goes
out to save energy.
Charging with the adapter
1 Put the small plug in the shaver.
2 Put the adapter in the wall socket.
The charging light shows the charging status of
the shaver (see section ‘Charge indications’ in
this chapter).
-
-
-
-
-
,
ENGLISH 9