User guide

Hooking Up Your TV (Antenna/Cable Connections) (Cont’d)
VCR Connections
l^iBEGIN)-
T
' he basic Antenna/Cable to
VCR to TV connection is
shown here. If you have a Cable
Box, refer to the VCR owner's
manual for details.
<i>^ Connect your
Antenna or Cable signal to
the IN FROH ANT(enna)
jack on the VCR.
<p-
Connect a coaxial
cable to the OUT TO
TV jack on the VCR
and to the ANT(enna)
IN jack on the TV.
The coaxial cable may be
supplied with the VCR.
<a>'
Refer to the VCR
owner's manual for other
possible connections and for
operating details.
300 to 750
Adaptor
Outdoor
VHF/UHF
Antenna
Cable TV signal
E
tBEGIN)-
y
bur Cable TV signal may be
a single (75Q) cable or a
Cable Box installation. In either
case, the connection to the TV is
very easy.
<4> If you do not have a
Cable Box, then you're ready
to connect your Cable TV sig
nal to the TV.
If you have a Cable Box:
Connect the Cable TV signal to
the IN jack on the Cable Box.
<l>-
If you do not have a
Cable Box, connect the Cable
TV signal directly to the
ANT(enna) IN jack on the TV.
If you have a Cable Box:
Use a coaxial cable to connect
the OUT jack of the Cable Box
to the ANT(enna) IN jack on
the TV
NOTE: The coaxial cable might
be supplied by the Cable TV
company.
Note to the Cable TV System
Installer: This reminder is provided to call
the Cable TV system installer’s attention to
Article 820-40 of the National Electrical
Code, which provides guidelines for proper
grounding - in particular, specifying that the
cable ground shall be connected to the
grounding system of the building, as close
to the point of cable entry as possible.
Back of TV
To select
only the channels
on your Cable sys
tem, see Auto Install
below. (You can not
use AUTO INSTALL
if you are using a
Cable Box.)
If you use a Cable
Box, set the TV to
the same channel as
the CH 3/4 switch
on the back of the
Cable Box and
select channels at
the Cable Box.
Setting Up and Using Your TV
Auto Install
f
'allow these steps to quickly
odd area channels into the
TV's memory.
^BEGINl
i4>
Press the POWER
button to turn ON the TV.
<l>
<2> Press the MENU but
ton.The main menu appears on
the TV screen.
SETUP
EXIT ►
I BRIGHTNESS ................. lïilïüF .............
COLOR llllliii 31
PICTURE ............... I 31
Press the CH(annel)
A/T buttons to select
SETUP.Then, press the
VOL(ume) ► or ◄ button
to continue.
FM ANTENNA EXT^
EXIT
►
1 LANGUAGE ÉÑG]
AUTO INSTALL
►
CHANNEL EDIT
<p<î>
<4>-
Press the CH(annel) A/V
buttons to select AUTO
INSTALL.
EXIT
LANGUAGE
I AUTO INSTALL
CHANNEL EDIT
FM ANTENNA
Then, press the VOL(ume) ►
or M button to enter AUTO
INSTALL, which will set up the chan
nels.
I AUTO STORE llllliii
When setup is complete, the
SETUP menu will appear for a
moment, then the lowest stored
channel will be selected. Now,
when you press the CH(annel)
A/T buttons, you will only scan
through channels that have been
memorized and are available.
-3-