User manual

Warranty restrictions
The shaving heads (cutters and guards)
are not covered by the terms of the
international warranty because they are
subject to wear.
Troubleshooting
This chapter summarises the most common
problems you could encounter with the
appliance. If you are unable to solve the
problem with the information below, contact
the Consumer Care Centre in your country.
Problem Possible
cause
Solution
The
shaver
does not
shave as
well as it
used to.
The shaving
heads are
dirty. You
have not
cleaned the
shaver well
enough or
you have
not cleaned
it for a long
time.
Clean the
shaver thor-
oughly before
you continue
shaving. See
chapter
‘Cleaning and
maintenance’.
Long hairs
obstruct
the shaving
heads.
Clean the
cutters
and guards
with the
cleaning brush
supplied.
See chapter
‘Cleaning and
maintenance’,
section ‘Every
two months:
shaving heads’.
The shaving
heads are
damaged or
worn.
Replace the
shaving heads.
See chapter
‘Replacement’.
The
shaver
does not
work
when I
push the
on/off
slide up-
wards.
The
batteries
are placed
incorrectly.
Make sure
the + and -
indications on
the batteries
match the
indications in
the battery
compartment.
The bat-
teries are
empty.
Replace the
batteries.
See chapter
‘Preparing for
use’.
Every two months: shaving heads
Note: Do not use cleaning agents or alcohol
to clean the shaving heads. Only use Philips
Cleaning Spray (HQ110).
1 Switch off the shaver.
2 Press the release button (1) and pull
the shaving unit straight up off the
shaver (2) (Fig. 10).
3 To remove the retaining frame,
push the sides of the central spring
towards each other (1). Then lift the
retaining frame out of the shaving unit
(2) (Fig. 14).
4 Slide the shaving heads out of
the retaining frame. Remove and
clean one shaving head at a time.
Each shaving head consists of a cutter
and a guard (Fig. 15).
Note: Do not clean more than one cutter and
guard at a time, since they are all matching
sets. If you accidentally mix up the cutters
and guards, it may take several weeks before
optimal shaving performance is restored.
5 Remove the guard from the
cutter (Fig. 16).
6 Clean it with the short-bristled side of
the cleaning brush. Brush carefully in
the direction of the arrows (Fig. 17).
7 Clean the guard with the long-bristled
side of the cleaning brush (Fig. 18)
8 Put the cutter back into the guard
after cleaning (Fig. 19).
9 Slide the shaving heads back into the
retaining frame. (Fig. 20)
10 Put the retaining frame back into the
shaving unit (‘click’) (Fig. 21).
11 Put the shaving unit back onto the
shaver (Fig. 13).
Storage
Keep the appliance dry.
Use and store the appliance at a
temperature between 5°C and 35°C.
1 Switch off the shaver.
2 Put the protection cap on the shaver
after use to prevent damage and to
avoid dirt accumulation in the shaving
heads (Fig. 22).
Problem Possible
cause
Solution
My skin
is irritat-
ed after
shaving.
Your skin
needs time
to get used
to the Philips
shaving
system.
Skin irritation
during the
rst 2-3
weeks of use
is possible. Af-
ter this period,
the skin irri-
tation usually
disappears.
The
rotation
speed
of the
shaving
heads is
slower
than
usual.
Too much
dirt has
collected in
the shaving
heads.
Clean the
shaving heads.
See chapter
‘Cleaning and
maintenance’.
The bat-
teries are
empty
Replace the
batteries.
See chapter
‘Preparing for
use’.
The ap-
pliance
makes a
strange
noise.
Too much
dirt has
collected in
the shaving
heads.
Clean the
shaving heads.
After cleaning,
lubricate the
central point
on the inside
of the guards
with Philips
Clean-
ing Spray
(HQ110).
See chapter
‘Cleaning and
maintenance’.
The shaving
heads are
damaged or
worn.
Replace the
shaving heads.
See chapter
‘Replacement’.
Replacement
Replace the shaving heads every two years
for optimal shaving results.
Replace damaged or worn shaving heads
with Philips shaving heads only (HQ4+ for
China or HQ56 for the rest of the world).
For instructions on how to remove the
shaving heads, see chapter ‘Cleaning and
maintenance’, section ‘Every two months:
shaving heads’.
Accessories
To retain the top performance of your
shaver, make sure you clean it regularly
and replace its shaving heads at the
recommended time.
Shaving heads
- We advise you to replace your shaving
heads every two years. Always replace
them with Philips shaving heads only
(HQ4+ for China or HQ56 for the
rest of the world) (Fig. 23).
Cleaning
- Use Philips Cleaning Spray (HQ110)
to clean the shaving heads thoroughly.
Recycling
- Do not throw away the product with
the normal household waste at the
end of its life, but hand it in at an
ofcial collection point for recycling.
By doing this, you help to preserve the
environment.
- This product contains disposable
batteries which shall not be disposed of
with normal household waste.
- Follow your country‘s rules for the
separate collection of electrical and
electronic products and batteries.
Correct disposal helps prevent negative
consequences for the environment and
human health.
Removing disposable batteries
To remove disposable batteries, see the
instructions for placing and/or removing
batteries in the user manual.
Always remove empty disposable batteries
from the product. Take any necessary safety
precautions when you dispose of batteries.
Warranty and support
If you need information or support, please
visit www.philips.com/support or read the
international warranty leaet.
繁體中文
簡介
感謝您購買本產品並歡迎加入飛利浦！
請於 www.philips.com/welcome 註冊
您的產品，以善用飛利浦提供的支援。
一般說明 (圖 1)
1 保護蓋
2 電鬍刀刀頭
3 除毛刀頭組
4 固定架
5 固定架的中央彈簧
6 釋放鈕
7 毛髮收集室
8 開/關 (On/Off) 滑動開關
9 電池槽蓋
10 飛利浦噴霧清潔劑 (HQ110) (選購)
11 刀具
12 刀網
13 清潔刷
重要安全資訊
使用本產品與其配件前，請先仔細閱讀
此重要資訊，並保留說明以供日後參
考。 提供的配件可能隨產品而異。
警示
- 本產品可供 8 歲以上兒童、身體
官能或心智能力退化者，或是經驗
與使用知識缺乏者使用，但需有人
從旁監督或指示如何安全使用本產
品，且使用者需了解使用本產品的
潛在危險。 請勿讓小孩把玩本產
品。 若無人監督，請勿讓兒童進行
清潔和使用者維護。
- 使用前請務必檢查本產品。 若產品
受損請勿使用，以免受傷。 零件如
有受損，請務必以原型號更換之。
警告
- 本產品不可水洗。請勿將本產品浸
泡在水中，或者在水龍頭下沖洗
(圖 2)。
- 本產品儘限用於本使用手冊所述之
相關用途。
- 請於 15°C 到 35°C 間使用並存
放本產品。
- 為保衛生起見，請勿多人共用本
產品。
- 請勿將本產品直接曝曬在陽光下。
- 本產品限用 1.5V AA 鹼性電池。
- 請勿混用不同類型的電池或新舊
電池。
- 請勿將非充電式電池重複充電。
- 裝入電池請確認 + 和 - 極方向正確
無誤。
- 電池的電源接頭不可發生短路
- 如果您長時間不使用本產品，請取
出本產品的電池。