Institutional Television Instructions for use PA0II3C PA0I27C PA0I32C PA90I9C PA9027C PA9032C PPCI27C PPCI32C PPCI36C PPC927C PPC932C SC3I32N SC3I36N * TELEVISION 3135 015 20912
Introduction Your Philips Institutional Television tuning system is set to operate in either "Consumer" or "Commercial" type product modes. In the Consumer mode the tuning system operates as a standard TV, allowing normal initial power ON, channel selection, and volume control (as well as a variety of select Menu features). Use the supplied remote control to adjust the TV in the Consumer mode.
SAFETY INSTRUCTIONS - Read before operating equipment This product was designed and manufactured to meet strict quality and safety standards. There are, however, some installation and operation pre cautions which you should be particularly aware of. 1. Read Instructions - All the safety and operating instructions should be read before the appliance is operated. 2. Retain Instructions - The safety and operating instructions should be retained for future reference.
Tabi.e of Contents Introduction Remote Control Operation with Accessory Devices (VCRs. Cable TV Converters. DVDs, etc.) Consumer and Commercial Menus............ 2 Safety/Precautions................................................... 3 B Table of Contents.....................................................4 Setting the Remote to Work Other Devices.......... 25 Features.................................................................... 5 Hooking Up Your TV.............................................
Features Philips exclusive "Pro Video" control tuning soft ware which allows operation of the TV in either "Consumer" or "Commercial" modes (depending upon its applied purpose and use). As you unpack your TV please note that the fol lowing items have been included with your set: Audio/Video jack panel for direct connections with VCRs (or other video accessories) for quality TV pic ture and sound playback. Note: Use of various Audio/Video connection jacks, or input modes (i.e., S-VIDEO, etc.
mi HooKiNC Up Your TV Antenna O utdook /I ndoor combination (outdoor or indoor) antenna receives normal broadcast channels 2-13 (VHF) and 14-69 (UHF). Your con nection to such an antenna is easy since there is only one antenna plug (75Q. ANT ¡CABLE) on the hack of your TV - and that’s where the antenna goes. A :gin)your antenna has a round cable (75 ohm) on the end, then you're ready to con nect it to the TV.
Basic TV and Remote Control Operation fBEGIN] Press the POWER button to I turn on the TV. Press the VOL(ume) A/T I buttons to adjust the sound level. 6 CH WXYZ Press the CH(annel) A/ T buttons to select TV channels. Point the remote control <$>. toward the remote sensor on the TV when operating the TV with the remote. Note: Always press two number buttons on the remote when selecting channels. For example: press "0," then "6," for channel 6. To load the supplied batteries into the remote: 1.
UsiN(i THE TV Remote Control Smari' Hklp Remember, always point the remote control toward the remote sensor on the TV when operating the TV with the remote. Sleep Button Power Button Press to set the TV to automatically turn itself OFF. Also can be used as an Enter but ton when sending channel commands to remote controlled cable converters or VCRs. Press to turn the TV (or select VCR, Cable Converter, etc.) ON and OFF.
How TO Use the On-Screen Menu o TJ'eatures for your TV can be ± adjusted from a Menu screen shown on the TV. Each Menu item can be adjusted by viewing the screen and pressing a button. tBEGIN) Press the Menu button on the remote. The on-screen menu appears. <1^1^ Press Menu button repeated ly, or use the Cursor (A) Up and Down (T) buttons on the remote, to select a feature control. A highlight bar will show the selected feature.
How TO Set the TV eor Cabee TV Operation ake sure the TV is set to pick up either Cable TV stations or Antenna signals. In other words, the TV needs to know whether you’ve connected a Cable TV signal or a normal antenna to its 75Q. ANTICABLE plug. M 1 MAIN MENU 1 LANGUAGE ENGLISH CHANNEL INSTALL ICABLE TUNING 0N|Wn BRIGHTNESS Hill- —fyiOTF] COLOR ■ 22 CONTRAST ■li....
Channel Installation: Adding Channels (AutoProgram \Zour TV can automatically set J. itself for local area (or Cable TV) channels. This makes it easy for you to select only the TV sta tions in your area when you use the CH(annel) +, - buttons. CBEOIN) With the Main Menu onscreen press the Menu button repeatedly , or use the Cursor (A) Up and Down (T) buttons, to select CHANNEL INSTALL with the TV’s highlight control bar.
□ Channel Installation: Ai)DiN(i Channels (Manually) uto Programming (see previ ous page) adds all the chan nels it can find (on your Antenna or Cable TV system) into the TV's memory. You may add other chan nels, or drop unwanted channels from the list of channels in the TV's memory.
Channel Installation: Input Control 'The Channel Installation Input -L control directs the TV to select an indicated input source (Auxiliary, Antenna, Front AIV, etc.) whenever a specific channel number is tuned. fBEGIN] CHANNEL INSTALLATION | TV 4 CHANNEL IHANNaRIHG OeiETED ANTF^Nfl! NPUT LABEL ( LEW SyiDEQ 1 With the Channel Installation Menu onscreen press the Menu button, or use the Cursor (A) Up and Down (T) buttons, to select INPUT with the TV’s highlight con trol bar.
□ How TO Adjust the TV Color o adjust your TV color and pic ture controls, select a channel, then follow these steps: iBEaiN) Smart T With the Main Menu onscreen press the Menu button repeatedly, or use the Cursor (A) Up and Down (T) buttons, to select the desired control (BRIGHTNESS, COLOR, etc.) with the TV’s high light control bar. 1 MAIN MENU 1 LANGUAGE ENGLISH CHANNEL INSTALL ► CAHIPTIIMINR ON IBRIRHTNFS.«: 34 1 COLOR ii nil— CONTRAST iiiiiii-"- 29 SHARPNESS lliil"40 TINT --H......
Using the Bass, Treble, Balance Controls ~\^our TV has individual sound A. adjustment controls. The speaker BALANCE, TREBLE (high frequency), and BASS (low frequency) controls may be used to adjust the sound quality of TV programs. 1 MAIN MENU 1 IRAIANOF —01 TREBLE — 31 nn- - 31 ^ 8ASS ilLTR.
□I Using the Automatic Volume Limiter (AVL) Control utomatic Volume Limiter (AVL) allows you to preset a desired volume level that the TV sound will not go above or exceed. This makes for an even, more consistent sound by reducing the “peaks” and “val leys" that can occur during commer cials and other program breaks. A 1 MAIN MENU ! SALANCf --•».... 0 TREBLE 1№.....31 BASS m 31 UlTflAfiASS ON .
Using the Audio/Video Mute 'XZou can use the AudiofVideo Mute J. control option to set the back ground color for the TV screen (when the TV is set to a blank chan nel that is not receiving an active video signal). CBEOIN) With the Main Menu onscreen press the Menu button repeatedly , or use the Cursor (A) Up and Down (T) buttons, to select AUDIO/VIDEO MUTE with the TV’s highlight control bar. Try it out. Press the CH (+, -) buttons.
How TO Select the Closed Caption Feature losed Captioning allows you to read the voice content of televi sion programs on the TV screen. Designed to help the hearing impaired, this feature uses on screen "text boxes" to show dia logue and conversations while the TV program is in progress. C NOTE: Not all TV programs and product commercials are broadcast with Closed Caption (CC) information included.
Using the V-Chip or Content Advisory Control new Program Content Advisory system is available to censor TV program material for viewing. TV Ratings and Movie Ratings advisory data will soon be contained within the broadcast signals of received TV programs. When setup by the viewer, the TV can respond by blocking or denying access to TV shows (based on whether the program meets or exceeds the limitations you select as viewable).
□ Using t h e V-Chip TV Ratings Control he TV Ratings control can be very specific in the degree and extent of program material cen sored for TV viewing. Sub-settings fora variety of blocking factors can be manually switched On or Off for use within the major TV Ratings categories (TV-Y7, TVPG, etc.).
Using the V-Chip Movie Ratings Control ovie Ratings set viewing access levels for TV pro gramming according to current Motion Picture Association of America (MPAA) ratings. These ratings are similar to the cate gories used with the rated movies appearing in cinema theaters and with video rental material.
Setting the Sleep Timer ave you ever fallen asleep in front of the TV, only to have it wake you up at two in the morning with a test pattern screeching in your ears? Well, your TV can save you all that trouble by automatically turning itself off. Q ioiiC With the Main Menu onscreen press the Menu button repeatedly, or use the Cursor (A) Up and Down (T) buttons, to select SLEEPTIMER with the TV’s highlight control bar.
How TO Use the On-Screen Language Option T^or our French and Spanish L speaking TV owners, an on screen LANGUAGE option is available. You may set the TV’s onscreen menu to appear in either English, French, or Spanish text. a ioiR) With the Main Menu onscreen press the Menu button repeatedly, or use the Cursor (A) Up and Down (T) buttons, to select LANGUAGE with the TV’s highlight control bar. <î> Smart Help ILANGUAGE CHANNEL INSTALL CABLETUNiNQ BRIGHTNESS COLOR CONTRAST SHARPNESS TINT NOiSF.
□I UsiN(i THE Audio Output Jacks ould you like to hear TV pro grams through your audio hifi system? The TV's Audio Output jacks ojfer you this sound playback option. W Sound from the TV's internal speakers may be eliminated by setting the SPEAKERS switch on the rear of the set to EXT. BACK OF TV fBEOINl Connect the R(ight) and L(eft) VARIABLE AUDIO OUT jacks on the TV to the R and L Audio Input jacks on your amplifier or sound system. Set the audio system's volume to normal listening level.
Setting the Remote Control To Work With Other Devices our remote control is set to work your TV and many infrared remote (IR) control VCRs, Cable Boxes, Satellite Systems, DBS, DVD, etc. However, an easy onetime step may be necessary before the remote will work your accessory. F SLEEP o Try this initial check to see if going on to the following section is necessary. A/CH STATUS/EXIT CC [BEGIN) Place the TV/VCR/ACC Mode Switch in the proper posi tion.
Setting the Remote Control To Work With Other Devices Direct Access Method A Tow that you have looked up 1 V the three-digit Remote Code Number for your brand of device, you are ready to follow the sim ple steps shown below. Please read through steps 1-4 before beginning. (BEGINt Place the TV/VCR/ACC Mode Switch in the proper posi tion. Press the (A/CH) • RECORD button on the remote control and release. Press the SmartSound button on the remote within 30 seconds, then release.
Setting the Remote Control To Work With Other Devices Search Method our TV remote can be set to work various external devices such as VCRs, Cable Boxes, Satellite Receivers, DBS, DVD, etc. by what is called the search method. F Satellite Receiver If the “Remote Code’’ number method shown on the previous pages did not set your remote to work your external device, then follow the easy steps listed below. Please read steps 1-4 before beginning.
Remote Control Direct Entry Codes REMOTE VCR CODE NO. Admiral.............. ...................................... 048 Advantz.............. ...................................... 358 Adventure .... ...................................... 000 Aiko ................... ...................................... 278 Aiwa.................. . .000, 037, 307, 348, 352 Akai ................ 041, 049, 053, 061, 106, 315 Alba.................... ...................................... 352 Amercian High ...................
Remote Control Direct Entry Codes CABLE CONVERTOR Eastern........................... Everquest....................... Filmnet ......................... Focus ............................ France Telecom............. GC Electronics ............. GEC .............................. Ganard........................... Gemini........................... General Instrument . . . Gold Star....................... Grundig......................... Hamlin............................ Hitachi...........................
Using the Remote’s VCR Buttons WJh^n using the TV remote yy with aVCR, first make cer tain it is set to control your VCR (by the REMOTE CODE or SEARCH method). (BEGIN! I Set the TV/VCR/ACC mode switch to VCR on the remote. POWER BUTTON Press to turn the VCR ON and OFF. Point the top of the remote toward the front of the VCR (remote sensor window) when pressing the buttons.
Description of On-Screen Controls (commercial mode) epending on the model and its features, some or all of the display functions and features described here will be valid. Note: Certain features which are found in both the Commercial and Consumer modes may be selected and adjusted in the same manner (for example: Language, Cable Tuning, Brightness etc.). Many of these shared onscreen Menu features are already described and explained in detail in the preceding Consumer mode sections.
□I Description of On-Screen Controls (commercial) contincei) LANGUAGE - See page 23 on the use of the English/Francais/or Español Menu language option control. Note: This control is intend ed for onscreen Menu items. The language of Labels, Closed Captioning, and other Channel Guide information will not change. CHANNEL INSTALL - See previous page for details on SubMenu containing Program Channel, Input, Label, AJV Blank, and Auto Program controls.
Description of On-Screen Controls (commercial) continued SAVE V-CHTP - Highlight SAVE V-CHIP, then press the Cursor Right (►) or Left (-^ ) buttons to select ON (or OFF). “ON”will save the current V-CHIP control settings within the TV’s memory. SECURITY - Highlight SECURITY, then press the Cursor Right (►) or Left (-^) buttons to select STANDARD (or HIGH).
Tips If Something Isn’t WoRKiNCi lease make these simple checks before calling for service. Theses tips can save you time and money since charges for TV installation and adjustment of customer controls are not cov ered under your warranty.
Glossary of Television Terms Menu - An onscreen listing of feature controls shown on the Television Coaxial Cable ■ A single solid antenna wire normally matched with a metal plug (F-type) end connector that screws (or pushes) directly onto a 75 Ohm input found on the Television or VCR. screen that are made available for user adjustments. Programming - The procedure of adding or deleting channel numbers into the Television’s memory circuits.
LIMITED WARRANTY COLOR TELEVISION One Year Free Labor One Year Free Service on Parts (Two Years Free Service on Color Picture Tube) This product can be repaired in-home. WHO IS COVERED? MAKE SURE YOU KEER.. You must have proof of purchase to receive warranty service. A sales receipt or other document showing that you purchased the product is considered proof of purchase. Please keep your sales receipt or other document showing proof of purchase. Attach it to this owner’s manual and keep both nearby.
