Portable DVD player with Dual Display Screens Register your product and get support at www.philips.
1. Important 1.1 Safety instructions 1.2 Environmental information 1.3 Power Sources 1.4 Hearing Safety 2. Introduction 2.1 Your portable DVD player 2.2 Unpacking 2.3 Overview 2.3.1 Main unit controls 2.3.2 Display controls 2.3.3 Remote Control 3. Prepration 3.1 Install the DVD player in car 3.2 Connect AV cable 3.3 Connect power cable 3.3.1 Power connection for the screens 3.3.2 Power connection for the DVD player 3.4 Insert battery into remote control 3.5 Connect headphones 4.4 Play discs 4.
1. Important 1.1 Safety instructions • • • • • • • • • • • • • • Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
• • • • or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. Battery usage: CAUTION To prevent battery leakage which may result in bodily injury, property damage, or damage to the unit: • Install all batteries correctly, + and – as marked on the unit. • Do not mix batteries (old and new or carbon and alkaline, etc.). • Remove batteries when the unit is not used for a long time.
to a product it means the product is covered by the European Directive 2002/96/EC. Please inform yourself about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste. The correct disposal of your old product will help prevent potential negative consequences for the environment and human health.
1.3 Power Sources This unit operates on a supplied AC adapter or car adapter. • Make sure that the input voltage of the AC adaptor is in line with the local voltage. Otherwise, the AC adaptor and unit maybe damaged. • Do not touch the AC adaptor with wet hands to prevent electric shock. • When connecting with car power (cigarette lighter) adaptor, be sure the input voltage of the adaptor is identical with car voltage.
1.4 Hearing Safety Listen at a moderate volume • Using headphones at a high volume can impair your hearing. This product can produce sounds in decibel ranges that may cause hearing loss for a normal person, even for exposure less than a minute. The higher decibel ranges are offered for those that may have already experienced somehearing loss. • Sound can be deceiving. Over time your hearing “comfort level” adapts to higher volumes of sound.
• Do not turn up the volume so high that you can't hear what's around you. • You should use caution or temporarily discontinue use in potentially hazardous situations. • Do not use headphones while operating a motorized vehicle, cycling, skateboarding, etc.; it may create a traffic hazard and is illegal in many areas.
2. Introduction Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. 2.1 Your portable DVD player Your portable DVD player plays digital video discs conforming to the universal DVD Video standard. With it, you can play movies with true cinema picture quality and stereo or multi-channel sound (depending on disc and playback set-up).
2.3 Overview Use the controls only as stated in the user manual. 2.3.
1 3, 4 2 J( )K Move cursor up / down Skip to previous/next chapter, track or title Move cursor to left/right 3 2; Start or interrupt play 4 MENU Enter or exit DVD menu 5 9 Stop play Enter or exit system setup menu 6 SETUP 7 p Headphones jack Adjust headphone volume 8 – VOL + Turn DVD player on/off 9 POWER B 10 POWER/IR Power/Remote sensor indicator 11 OPEN Open disc door to insert or remove disc 12 AV out 1 and 2 Audio/Video output jacks 13 DC OUT DC power output to the two screens 14 DC IN Power supply so
1 3 2 6 7 8 4 5
1 DISPLAY Setup screen display 2 POWER ON/OFF Turn the screen on/off 3 1, 2 Adjust display value of the screen 4 p Headphone jack Adjust volume 5 – VOL + 6 DC IN Power supply from the DVD player 7 Audio In L(left) and R(right) Audio/Video input jacks 8 VIDEO IN Video input jack 2.3.
1 SETUP Enter or exit system menu 2 3, 4, 1, 2 Move cursor up / down / left / right. OK Confirm selection 3 OSD Access available functions 4 J( Skip to previous chapter, track or title. 5 PLAY/PAUSE 2; Start / pause / resume play 6 MUTE Turn off sound 7 Numeric Keypad 0 - 9 Input numbers. 8 SUBTITLE Select a subtitle language for DVD disc.
3. Prepration 3.1 Install the DVD player in car 1 Strap the car pouches over your car seat headrest. 2 Insert the DVD player and the two screens into the pouches. 3 Close the buckle and adjust the belt until it fits tightly around the headrest. DVD Player Screen Screen Tip: You can place the main DVD player at anywhere in the car as long as the cables length allows. Fasten the pouch straps if you do not put the DVD player inside the pouch.
3.2 Connect AV cable There are two AV cables supplied, one for each screen is to be used. 1 Connect AV cable to the DVD player and to the screen as the figure shown below. Note: Match the color of the AV cable with the jacks: the yellow cable is for the yellow video jack, the red/white cable is for the red/white audio jacks.
3.3 Connect power cable 3.3.1 Power connection for the screens 1 Plug the green end of the supplied Y-type power cord to the DVD player first, then plug the other side with two ends to the twoscreens (see figure below).
3.3.2 Power connection for the DVD player option 1: using car adaptor 1 Connect the car cigarette adaptor to the DVD player and to the Car Cigeratte Lighter. (see figure below)l Car Cigarette Lighter Socket Option 2: Using AC adapter 1 Connect the AC adapter to the DVD player and the main power supply (see figure below).
3.4 Insert battery into remote control For first time use: Pull out the protective plastic tab. For change battery: 1 Open the battery compartment cover. 2 Insert 1 x CR2025 3V lithium battery. 3 Close the cover. 3.5 Connect headphones Plug the headphones into the p jack of your DVD player or screen.
4. Basic functions 4.1 Power on 1 Power on the DVD player and the two screens by: – Switch the POWER switch on the DVD player to ON position. – Press the POWER ON/OFF button on the screens. 4.2 Select On-Screen-Display(OSD) language English is the default language for screen display. You can change the display language by: 1 Press SETUP. 2 Press 1, 2, 3, 4 to select General > Language. 3 Select the language and press OK 4.3 Load disc 1 Press OPEN on the DVD player.
For MP3 CDs Use 1, 2, 3, 4 to select folder and MP3 file, then press OK to start play. For Picture CDs 2 3 4 5 Use 1, 2, 3, 4 to select folder and JPEG file, then press OK to view the picture. During play, press J( or § briefly to select the previous or next title/track/chapter. •To go directly to any title, track or chapter, enter the corresponding number using the numerical keys (0-9) Keep pressing J( or § to initiate fast backward/forward searching.
Contrast: to adjust the contrast ( Display ratio: 16:9 display mode ( 2 Press 1 or 2 to change value..
5. Special functions 5.1 Change audio language (for DVD) Some DVD contain two or more audio languages for selection.You can change language by: 1 Press AUDIO repeatedly. 5.2 Change subtitle (for DVD) If the disc contains two or more subtitle languages, you can 1 Press SUBTITLE. repeatedly to select the subtile language. 5.3 Change view angle (for DVD) If the disc contains different angle of view information, you can 1 Press OSD. 2 Press 1, 2, 3, 4 to select ANGLE, then press OK to confirm. 5.
5.6 Repeated play A-B repeat 1 Press A-B to set the starting point . 2 Press A-B again to set the ending point. • The DVD player starts play the loop repeatedly. 3 Press A-B to cancel repeat play. Repeat 1/all (For audio/MP3 CD) 1 Press OSD. 2 Press 1, 2, 3, 4 to select Repeat 1 or Repeat all, then press OK to confirm. 5.7 Random play (for audio/MP3 CD) 1 Press OSD. 2 Press 1, 2, 3, 4 to select Shuffle "On" or "Off", then press OK to confirm. 5.8 Rotate pictures (for picture CD) 1 Press OSD.
6. Setup operation You can change the following default settings of the DVD player by: 1 Press SETUP. A list of features is shown. 2 Press 3 4 to highlight the selection. 3 Press 2 to enter its sub-menu • Press 1 to return to the previous menu. 4 Press OK to confirm. 5 Press SETUP to exit. The SETUP menu includes: General Language Set On Screen Display (OSD) languages PBC settings Set Playback Control function ON/OFF. This feature is available for Super VCD.
7. Specifications Dimensions – DVD player 204 x 168 x 33 mm 8.0 x 6.6 x 1.3inches – Screens 204 x 168 x 33 mm 8.0 x 6.6 x 1.3 inches Weight - DVD player 1.9 kg / 4.2 pounds – Screens 1.9 kg / 4.2 pounds x 2 Power supply DC 12V 2.0A Power Consumption <20W Operating temperature range 0 - 50°C Laser wavelength 650nm Video system NTSC / PAL / AUTO PHILIPS reserves the right to make design and specification changes for product improvement without prior notice.
8. Maintenance 8.1 General • Do not use any cleaning agents containing alcohol, ammonia, benzene, or abrasives as these may harm the player. • Take care not to drop the unit or subject it to strong shocks,which may cause malfunction. • Do not touch the lens! 8.2 Handling discs • Do not attach paper or tape to the disc. • Keep the disc away from direct sunlight or heat sources. • Store the disc in a disc case after playback.
9.Troubleshooting If you encounter problems when using this DVD player, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site www.welcome.philips.com/ us_en/, or contact Philips (see Contact information). When you contact Philips, ensure that your micro system is nearby and the model number and serial number are available. To keep the warranty valid, never try to repair the system yourself. Symptom Remedy Screen shows 'no Signal'.
No sound Disc can’t be played The player does not respond to the remote control Distorted or B/W picture with DVD Player does not respond to all operating commands during playback Player feels warm • Check if both plugs of the mains cord are properly connected. • Check if there is power at the AC outlet by plugging in another appliance. • Check if battery pack is inserted appropriately. • Check if car adaptor is connected appropriately.
Copyright information The making of unauthorized copies of copy-protected material, including computer programmes, files, broadcasts and sound recordings, may be an infringement of copyrights and constitute a criminal offence.This equipment should not be used for such purposes. Important notes for users in the U.K. Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: 1 2 3 Remove fuse cover and fuse.
• As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: – Connect the blue wire to the terminal marked N or coloured black. – Connect the brown wire to the terminal marked L or coloured red. – Do not connect either wire to the earth terminal in the plug, marked E (or e) or coloured green (or green and yellow).
