Always there to help you Register your product and get support at www.philips.
Contents 1 Safety 2 2 What's in the box 3 3 Connect power 4 4 Turn on 5 5 Set the clock 6 6 Listen to FM radio stations 7 7 7 7 7 8 10 7 Listen to DAB radio stations 11 11 11 12 12 8 Use system menus 14 14 14 14 9 Listen to an external device 15 10 Adjust the volume 16 11 Troubleshooting 17 Search for a radio station automatically Search for a radio station manually Store radio stations automatically Program radio stations manually Display RDS information Adjust FM settings For the fi
1 Safety Read and understand all instructions before you use this product. If damage is caused by failure to follow the instructions, the warranty does not apply. Risk of electric shock or fire! • Never expose the product and accessories to rain or water. Never place liquid containers, such as vases, near the product. If liquids are spilt on or into the product, disconnect it from the power outlet immediately. Contact the Consumer Care to have the product checked before use.
2 What's in the box OR7200 User Manual EN 3
3 Connect power 4 EN
4 Turn on Press the knob or turn the SOURCE knob. »» The product switches to the last selected source. • To switch the product to standby mode, press the knob again.
5 Set the clock 1 2 3 4 5 In standby mode, press and hold the knob for 2 seconds. »» (12-hour time format) or (24-hour time format) blinks. Turn the knob to select a time format, and then press the knob to confirm. »» Hour digits blink. Turn the knob to set the hour, and then press the knob to confirm. »» Minute digits blink. Turn the knob to set the minute. Press the knob to confirm. 2 sec.
6 Listen to FM radio stations 1 2 Store radio stations automatically Turn the SOURCE knob to switch the product to FM mode. Search for radio stations automatically or manually. Note 2 sec. •• For optimal reception, fully extend the antenna and adjust its position. •• You can store a maximum of 30 FM radio stations. Search for a radio station automatically Press SCAN to activate the auto search. »» After a strong radio station is detected, the search stops and the radio station is broadcast.
5 • Repeat steps 1-4 to program more radio stations. To tune to a preset radio station, turn the PRESET knob until its frequency is displayed. Note •• If you store a radio station with the sequence number of another one, the earlier one is overwritten. Display RDS information Radio Data System (RDS) is a service that allows FM stations to transmit additional information. When you tune to an FM radio station that transmits RDS signals, the station name is displayed. 1 2 8 Tune to an RDS station.
RDS program types Program type NEWS AFFAIRS INFO SPORT EDUCATE DRAMA CULTURE SCIENCE VARIED POP M ROCK M MOR M LIGHT M CLASSICS OTHER M WEATHER Description News services Politics and current affairs Special information programs Sports Education and advanced training Radio plays and literature Culture, religion and society Science Entertainment programs Pop music Rock music Light music Light classical music Classical music Special music programs Weather Program type FINANCE CHILDREN SOCIAL RELIGION PHONE I
Adjust FM settings 1 2 In FM mode, press MENU to access FM menus. Turn the menus. knob to toggle through the 3 Press the knob to access sub-menus. Turn the knob to select an option. • : Search for strong stations only. • : Search for all stations no matter whether the signal strength of a station is strong or weak. Press the knob to confirm the option. Audio setting 1 2 3 10 Press the knob to access sub-menus. Turn the knob to select an option.
7 Listen to DAB radio stations 4 Turn the knob to select a station, and then press the knob to start listening. Tip •• You can re-scan to update the list of stored stations (see "Use DAB menus" > "Re-scan for stations"). Note •• You can tune to a station manually (see "Use DAB menus" > "Tune to a station manually"). •• For optimal reception, fully extend the antenna and adjust its position. •• You can program a maximum of 30 DAB radio stations. •• Check with local retailer or go to www.WorldDAB.
Display DAB information Re-scan for stations On the display of DAB broadcasting, the first line shows station name, and the second line shows the service information for the current station. Press INFO repeatedly to cycle through the following information (if available). • Dynamic label segment (DLS) • Signal strength • Program type (PTY) • Ensemble name • Frequency • Signal error rate • Bitrate codec • Time • Date Press the knob to start scanning for available DAB stations.
DRC (Dynamic Range Control) System menus DRC adds or removes a degree of compensation for the differences in the dynamic range between radio stations. 1 2 • 1 2 3 Press the menus. knob to access the sub- Press the knob to access system menus. Turn the knob to select a sub-menu. For details, refer to the section 'Use system menus'. Turn the knob to select an option. (The asterisk behind the option indicates the current setting.) • : No compensation applied. • : Medium compensation applied.
8 Use system menus Use the system menus to • check the version of current software of this product, • upgrade the software, and • reset the product to factory default status. Check the current software version Press the knob to display the version of current software. Reset the product 1 2 3 14 Press the knob to display the options. Turn the knob to select an option. • : Return to the previous menu. • : Reset the product to factory default status. Press the EN knob to confirm the option.
9 Listen to an external device You can also listen to an external audio device, for example, MP3 player, through this product. 1 2 3 Turn the SOURCE knob to switch the product to MP3-Link mode. Connect the audio input cable to • the MP3-LINK socket on the back panel of this product, and • the headphone jack on the external device. Play the external device (refer to its user manual).
10 Adjust the volume Turn the 16 EN knob.
11 Troubleshooting Warning •• Never remove the casing of this product. To keep the warranty valid, never try to repair the product yourself. If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www. philips.com/support). When you contact the Consumer Care, make sure that the product is nearby and the model number and serial number are available.
12 Product information Note •• Product information is subject to change without prior notice. Amplifier Frequency Response Signal to Noise Ratio Aux Input 60 Hz - 16 kHz, ±3 dB > 65 dB 0.5 V RMS 20 kohm Tuner Tuning Range Tuning grid DAB sensitivity (EN50248) Total Harmonic Distortion Signal to Noise Ratio Number of preset radio stations FM: 87.50 - 108.00 MHz; DAB: 174.928-239.
13 Notice Any changes or modifications made to this device that are not expressly approved by WOOX Innovations may void the user’s authority to operate the equipment. Compliance This product complies with the radio interference requirements of the European Community. Please act according to your local rules and do not dispose of your old products with your normal household waste. Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health.
2014 © WOOX Innovations Limited. All rights reserved. Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used by WOOX Innovations Limited under license from Koninklijke Philips N.V. OR7200_10_UM_V2.
