operation manual
31
32
Caution: Do not immerse the motor unit in
water or any other liquid, nor rinse it under the
tap.
Never use compressed air, scouring pads, abrasive
cleaning agents or aggressive liquids such as
petrol or acetone to clean the appliance.
Do not tap on the cutting elements.
Do not use any sharp objects to clean the cutting
elements.
1 Make sure the appliance is switched off.
2 Rinse the cutting element of the nose/ear
trimming head with hot water (Fig. 20) .
3 Switch on the appliance and rinse the cutting
element once more to remove any remaining
hairs. Then switch off the appliance again.
Tip: The best way to clean the cutting element is
to immerse it in a bowl with warm water for a few
minutes and then switch on the appliance (Fig. 21) .
Note: You can also use the cleaning brush to clean the
nose/ear trimming head (Fig. 22) .
ENGLISH
4 Rinse the eyebrow combs with lukewarm
water. (Fig. 23)
Note: You can also use the cleaning brush to clean the
eyebrow combs.
5 Rinse the precision trimming head and the
precision trimming comb with lukewarm
water (Fig. 24) .
Note: You can also use the cleaning brush to clean the
precision trimming head (Fig. 25) .
6 Let all parts dry completely before you use
the appliance again.
Storage
1 Place the protection cap on the trimming
head (Fig. 26) .
2 Store the appliance in the pouch supplied.
Replacement
If the cutting element, precision trimming head or
combs are damaged or worn, always replace them
with original Philips parts.
To buy accessories or spare parts, visit www.
philips.com/service or go to your Philips
ENGLISH
NT5175-16A7JPcs6.indd32 14/12/0814:06