operation manual
27
28
4 Slowly turn the trimming head around to
remove all unwanted hairs from your outer
ear channel (Fig. 10) .
5 To switch off the appliance, turn the battery
compartment cover to the ‘off’ indication
(0) (Fig. 9) .
Trimming eyebrows with the eyebrow
combs
1 Comb your eyebrows in the direction of hair
growth (Fig. 11) .
2 Choose the short or long comb, depending
on the desired hair length.
- short comb: 3mm/0.12in
- long comb: 5mm/0.2in
Tip: We advise you to start trimming with the long
comb. If you think your eyebrows are still too long
after this, use the short comb.
3 Slide the eyebrow comb onto the trimming
head (Fig. 12) .
Make sure that the eyebrow comb has been
properly slid into the grooves on both sides.
ENGLISH
4 Move the comb over the eyebrow from the
outer tip of the eyebrow towards the base
of the nose (against the direction of hair
growth) (Fig. 13) .
Shaping with the precision trimming
head
You can use the precision trimming head to shape
and maintain your beard, sideburns and neck hair.
You can also use the precision trimming head to
trim neck hair.
General
1 To detach the trimming head from the motor
unit, turn the trimming head anticlockwise
until the locking indicator points to the
‘unlocked’ indication. Then pull the trimming
head off the handle. (Fig. 14)
2 To attach the precision trimming head, align
the locking indicator with the ‘unlocked’
indication and put the precision trimming
head on the handle. Then turn the precision
trimming head clockwise until the locking
indicator points to the ‘locked’ indication
(I). (Fig. 15)
ENGLISH
NT5175-16A7JPcs6.indd28 14/12/0814:06