Important notes for users in the UK. i Mains plug ! This apparatus s fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: { 1 Remove fuse cover and fuse. , 2 Fix new fuse which should be 2 BS1362 5 Amp, PASTA. o] BS| approved type. 3 Refit the fuse cover. I the fitted plug is not suitable for your sucker outlets, it should be cut off and an appropriate plug fitted in its place. [f the mains plug contains a fuse, this should have a value of & Amp.
SCOPE OF DELIVERY GENERAL INFORMATION Remote control 2 Batteries for remote control Spiral wrap for cables Cinch cable Instructions for use {Environmental information All redundant packing material has been omitted. We have done our utmost to make the packaging easily separable into three mono materials: cardboard (box], polystyrene foam {butter) and polyethylene {bags, protective foam sheet). Your set consists of material which can be recycled if disassembled by a specialized company.
CONTROLS AND TERMINALS sor illustration tots out cover Controls at the front 1 POWER... ...Switches the Home Theater Amplifier on and off. 2 Power light RED: Home Theater Amplifier is in standby mode. 3 . Selects the TV input, 4 PROVIDENT 1. Selects the VCR and the DIVED 1 input. § LEONID 2 Selects the L0 and the VIDEO 2 input. & ...Selects the AUX/CD input. 7 Remote sensor & LEFT, CENTER, RIGHT, Light for the corresponding speakers goes on when TEST TONE is pressed on the remote control.
REMOTE CONTROL INSTALLATION fuggy Buttons en the remote control [Before you start... STANDBY Switches the Home Theater Amplifier to the standby mode. elects the TV input. elects the VCR and the VIDEO 1 input. 1. «...Selects the LD and the DIVED 2 input. AUX the AUX/COD input. PRO LOGIC Selects the Dolby Pro Logic mode. 3 the Dolby 3 Stereo made. CENTER MODE... Selects one of the three different center modes: Normal, Wide or Phantom. VOLUME 4/~ Adjusts the volume.
INSTALLATION POSITIONING Basic connections Positioning of the speakers | Important! Always switch off all your equipment before making any connections! 1 Connect both Surround Speakers to the Home Theater Amplifier by connecting the unmarked wire to the red terminal, and the black marked wire to the black terminal. 2 Connect the AU BID OUT {they could also be called LINE OUT or similar] sockets of your sources (TV, VR, LD, 10 the respective AUDIO (N sockets of the Home Theater Amplifier using cinch cables.
SOUND SETTINGS fuggy J [Basic sound adjustments | I Center modes 1 Switch on your audio system as usual. 2 Select the input used to connect the Home Theater Amplifier to your audio system. 3 If your source is a TV, VCR, or LD tum down the volume of your television completely. If your source is a CD player adjust its volume to a normal listening level. 4 Defect the source used with TV, VCR, LD, or AUX on the Home Theater Amplifier or the remote control.
TROUBLESHOOTING WARNING Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee. ! If a fault occurs, first check the points listed below before ‘ G taking the set for repair. you are unable to solve a problem by following these hints, ; { PROBLEM No sound POSSIBLE CAUSE VOLUME is not adjusted correctly. Wang input is selected. Speakers are not {or wrongly] connected. Home Theater Amplifier is not connected consult your dealer or service center.
