Short user manual Monolith Design cordless phone with answering machine (M995) Register your product and get support at www.philips.
Important safety instructions Warning • The Electrical network is classified as hazardous. The only way to power down the charger is to unplug the power supply from the electrical outlet. Ensure that the electrical outlet is always easily accessible. • Refer to safety information before using the product. • Hereby, Gibson Innovations declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.
Overview 1 In call Standby Enter the option menu. Change the sound profile. / Access the redial list. Adjust the volume. Phonebook Recall (network dependent). Call log End calls. / In menu Access the main menu (press and hold when there is a new event). Enter a pause (press and hold). Make and receive calls. Turn the speaker on/off. Access the network voice mail (network and country dependent) (press and hold). Mute/unmute the microphone. Switch the handset on or off (press and hold).
2 Connect 1 2
3 Get started Insert battery Charge your phone Charge 8 hours Charge your handset by docking it in either direction. > 70% 40% - 70% Configure your phone 1 When using your phone for the first time, you see a welcome message (country dependent). 2 Set the country and language if prompted. 3 Set the date and time. • If the time is in 12-hour format, press / to select [am] or [pm] (country dependent).
4 Enjoy Phonebook Call log Add record 1 Press . 2 Select [Option] > [Add new]. 3 Follow on-screen instructions. Call from the phonebook 1 Press . 2 Select a record and press . Call from the direct access memory Press and hold on the keys in standby mode. The availaibility of direct access memory is country dependent. Call from the call log 1 Press . 2 Select a record and press . Save record 1 Press > [Option] > [Save number]. 2 Follow on-screen instructions.
5 Learn more Silent mode Sets time during which the phone will not ring. > PIN (default:0000) > [Silent mode] MySound Customizes the sound of voices to your liking. > [MySound] Eco/ECO+ mode Reduces transmission power and radiation (causes 2 seconds ring delay, 50% shorter standby time). > [Eco mode]/[ECO+ mode] Call barring Prevents unwanted outgoing calls to selected numbers. > PIN (default:0000) > [Call barring] Block incoming calls Mutes the ringer for certain undesirable numbers.
Technical data Battery • Philips: NiMH 2.4 V rechargeable 550 mAh battery Use only the supplied batteries. Adapter Tenpao: S003EB06000302 Input: 100-240 V~ 50/60 Hz 200 mA Output: (i) 6 Vdc 300 mA; (ii) 6 Vdc 200 mA Phonebook with 100 entries Call log with 50 entries Talk time: 18 hours Standby time: 250 hours RF output power: < 24 dBm Frequency band: 1880 MHz ~ 1900 MHz Note You can find the Declaration of Conformity on www.p4c.philips.com.
Frequently asked questions My handset displays [Searching] or [Unavailable], or [Register your Handset], what do I do? • Make sure that the base station has power supply. • The handset is out of range. Move it closer to the base station. • The handset is not paired with the base. Register the handset to the base station. If I fail to pair (register) the additional handsets to the base station, what do I do? > > • Your base memory is full. Access [Unregister] to unregister the unused handsets and try again.
www.philips.com/support To access the user instructions online, use the reference model number written on the product label at the bottom of the base station.
2017 © Gibson Innovations Limited. All rights reserved. This symbol on a product means that the product is covered by European Directive 2012/19/EU. This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V. UMS_M995 05_EN_v2.
