Quick start guide

Quick Start Guide

What’s in the Box?

You should find these items upon opening the box.

User Manual

FM antenna MW antenna Remote Control

Quick Start Guide

User manual

MCM726

Pull out the plastic

protective sheet

before use.

MCM726 QUG_Eng 3/20/07, 5:36 AM1

PAGE 1
MCM726 Quick Start Guide What’s in the Box? You should find these items upon opening the box. Pull out the plastic protective sheet before use.
PAGE 2
1 Connect the speaker cables. 2 Connect the MW and FM antennas. 3 Connect the power cable of the system. Tip See the User Manual for how to connect other equipment to this system.
PAGE 3
Setting the clock IMPORTANT! – To set clock in the Eco Power mode, press and hold STANDBY-ON/ECO POWER 2 on the set for 3 seconds or more to switch to normal standby mode first before proceeding with the procedures below. 1 In standby mode, press and hold RDS/CLOCK SET on the system. 2 When the hour digits flash, turn the VOLUME control on the front panel to set the hours. 3 Press RDS/CLOCK SET again and the minute digits flash. Then turn the VOLUME control on the front panel to set the minutes.
PAGE 4
C Enjoy Playing a USB mass storage device With the Hi-Fi system, you can use USB flash memory (USB 2.0 or USB1.1), USB flash players (USB 2.0 or USB1.1), memory cards (requires an additional card reader to work with this Hi-Fi system). 1 Insert the USB device’s USB plug into the socket on the set. 2 Press SOURCE once or more to select USB (or USB on the remote control). 3 Play the USB’s audio files as you do with the albums/tracks on a CD.